Torque Multipliers General data ♦ GRIPHOLD' - manual torque multipliers, reach torques up to 50.000 Nm No further auxiliary units required All GRIPHOLD* - manual torque multipliers, are furnished with rachets. Types H 10 and H 15 are also available without rachets. The high - precision ratchet makes it possible for all jobs to be performed with an extreme degree of efficiency, even if very short ratchet movements are exerted. All sun wheels of all GRIPHOLD* - manual torque multipliers, are manufactured using a high -precision process. Non - cutting - in order to ensure the highest possible stress and absolute minimum wear. The tooth is permanently fixed to the support without any internal boring. The sun wheels are embedded in bearings on both sides. The compressed collet chuck steel, with the solidity of forged parts, guarantees that GRIPHOLD" precision gear wheels can be subjected to the highest possible load factor. Note: The exactness of the torque transfer is dependent on the tolerance of the torque wrench used. Technical data without ratchets *} At maximum load, please note that there is an available reserve of 20% for possibly increased loosening torques. **) Overloading of square drive 1/2" and 3/4" means driving breakage. The shearing pin for security will not help much in this case. The following drive options are available for GRIPHOLD* - manual torque multipliers, 3/4" internal square socket torque wrench or conventional rachets external hexagonal socket SW 36 mm. Connector: 1/2" internal square socket - 3/4" external square socket Hand wheel - for positioning of loose screws. Rachet or torque wrenches available as optional accessories! GRIPHOLD9 - manual torque multipliers, are supplied with a support arm as a standard version. For support rings and back stops, see the GRIPHOLD* list of accessories. GRIPHOLD9 - manual torque multipliers, provide safe, economic and problem-free operation. They replace impact wrenches, pipe extensions and other insufficient methods. They improve on-the-job safety and provide short assembly times. You should make use of a GRIPHOLD" - manual torque multipliers, in future! [email protected] • www.griphold.com Specifications subject to change without notice