SERIES 68B Hall Effect Rocker Switch FEATURES • Choice of ratiometric analog or PWM outputs • Sealed to IP67 dynamic - even during actuation • Rugged industrial design suited for outdoor use • Provides positive tactile feedback in any environment • Long operational life • Redundant output for safety • Available with 26°detent and 36° latching, friction hold, or spring return (no detent) • Choices of cable length • Choices of accent color APPLICATIONS • Dash-panel and armrest controls • Hydraulic fluid flow control • Engine speed control • Heavy duty industrial equipment • Remote control belly boxes DIMENSIONS in inches, [mm] MOUNTING PANEL OPTIONS MOUNTING PANEL RECOMMENDATIONS: 1. FASTENERS SHOULD BE #4 THREAD FORMING SCREWS FOR PLASTIC. 2 . MOUNTING TORQUE TO BE 3-5 IN.LBS, 8 IN.LBS MAXIMUM. 3. DIAMETER OF MOUNTING HOLES IN CUSTOMER PANEL TO BE 0.130" [3.30mm]. DIAMETER OF MOUNTING HOLES IN SWITCH ARE 0.100" [2.54mm]. 4. LENGTH OF MOUNTING SCREWS TO BE: (PANEL THICKNESS) + 0.140" [3.56mm] OR LESS. 5. MINIMUM SPACING BETWEEN TWO UNITS IS 1.080" [27.43 mm] FROM CENTERLINE TO CENTERLINE. Grayhill, Inc. • 561 Hillgrove Avenue • LaGrange, Illinois 60525-5997 • USA • Phone: 708-354-1040 • Fax: 708-354-2820 • w

Joysticks BLOCK DIAGRAM Hall Effect Sensor 1 Hall Effect Sensor 2 PINOUT AND WIRE COLOR CHART PINOUT FOR DEUTSCH CONNECTOR P/N DTM06-4S ANALOG OUTPUT WAVEFORM POSITIVE/NEGATIVE DIRECTION REFERENCE VDD = 5.00V (FOR REFERENCE ONLY) PWM OUTPUT WAVEFORM V HIGH FAILURE INDICATIONS* * IN CASE OF ERROR THE SENSOR CHANGES THE PWM FREQUENCY TO 50% OF THE NORMAL OPERATING FREQUENCY DUTY CYCLE DEFINED AS THE RATIO BETWEEN THE HIGH TIME (S) AND THE PERIOD (D) OF THE PWM SIGNAL AS SHOWN IN FIGURE ABOVE. Grayhill, Inc. • 561 Hillgrove Avenue • LaGrange, Illinois 60525-5997 • USA • Phone: 708-354-1040 • Fax:...

SPECIFICATIONS Electrical Specifications Operating Voltage on Pin 1 (Vdd): 5.0V ± 0.5V Absolute Maximum Voltage* on Pin 1 (Vdd): -18 V min, +18 V max (t < 1 h) Operating Current: 15 mA typ., 20 mA, max. Analog Output Voltage is Analog (Ratiometric to Operating Voltage) Output at Center Position: 50% Vdd Output at Full Travel: 10% Vdd or 90% Vdd depending on configuration Output Voltage Tolerance: ± 3% Vdd at full travel ± 5% Vdd at center position Output Current: 1 mA, max. Recommended Load: 10 K Ohm pull-down resistor. Sensor Error: When a sensor error occurs, the output goes to < 4% of operating...