For Single-Line Parallel Automatic Lubrication Systems. For professional use only. Part No.: 24A918 3500 psi (24 MPa, 241 bar) Maximum Working Pressure Important Safety Instructions PRESSURE RELIEF PROCEDURE Follow this procedure any time you are instructed to Relieve the Pressure; shut off the pump; clean or service any part of the system; or install or clean dispensing devices. Read all warnings and instructions in this manual. See your Automatic Lubrication System Manual for complete Warnings, Installation, Operation and Troubleshooting instructions. Save all instructions. 1. Disconnect power. 2. Disable air supply to pump by either: • • Closing bleed-type air valve OR Disconnecting quick disconnect air coupler on vent valve. SKIN INJECTION HAZARD High-pressure fluid from gun or dispense valve, hose leaks, or ruptured components will pierce skin. This may look like just a cut, but it is a serious injury that can result in amputation. Get immediate surgical treatment. • Do not point gun or dispense valve at anyone or at any part of the body. • Do not put your hand over the dispense outlet. • Do not stop or deflect leaks with your hand, body, glove, or rag. • Follow Pressure Relief Procedure, when you stop dispensing and before cleaning, checking, or servicing equipment.

3500 psi (24 MPa, 241 bar) 1000 psi (6.9 MPa, 69 bar) 2500 psi (17 MPa, 172 bar) 600 psi (4.1 MPa, 41 bar) fAdjustable: 0.050 to 0.500 in.3 Carbon steel, Stainless steel, Copper, Fluoroelastomer Lubricant: NLGI 000 - NLGI Parts A Torque to 70 - 80 ft lbs. A Apply grease/lubricant A Hand tighten until contact with 8. , Technical Data Maximum Working Pressure Minimum Operating Pressure Suggested Operating Pressure Reset Pressure Output Volume Per Cycle Wetted Parts Recommended fluids f Maximum adjustment setting is when adjusting screw (3) is just making contact with indicator pin (8) with...