PROFITEST H+E EXPERT CHECK
3Pages

PROFITEST H+E EXPERT CHECK Test Instrument and Function Tester for AC Charging Points per IEC 61851-1, VDE 0122-1 • Unique function tester for AC charging points • Also for AC charging points with permanently attached cable • Intuitive operation • Simple test sequence saves time and money • Results appear at the display in plain text • Error display with results for forwarding to service personnel • Easy fault simulation by simply pressing a key, e.g. normative interruption of PE with indication of tripping time < 100 ms • Communication evaluation (PWM signal) • Measuring inputs and earthing contact socket for use in combination with instruments from the PROFITEST MF series or the PROFITEST MASTER IQ series for testing protective devices at charging points (electrical testing) • USB port for charging the battery The number of charging points that don’t function reliably in the long term is also increasing along with steady expansion of the AC charging infrastructure. If the charging process can’t be started, malfunctioning of the AC charging point is usually assumed. As a result, the operator confidently seeks the help of a specialist, namely an e-mobility electrician. • Testing of AC charging points in charging mode 3 • Vehicle simulation (CP): simulation of an electric vehicle’s charging socket • Connection to the charging socket or the type 2 plug of an AC charging point • Cable simulation (PP): testing of 13, 20, 32 and 63 A cables, and testing for “no cable connected” • Testing of vehicle states A, B and C, phases, tOFF (state E), rotating field and duty cycle, as well as frequency • Fault simulation: diode test, CP-PE short-circuit (state E) and PE fault (ground fault with display of tripping time) • PWM signal evaluation (communication): display of positive and negative PWM voltages • Electrical testing of charging points in combination with instruments from the PROFITEST MF or PROFITEST MASTER IQ series: – Continuity of the conductors (low-resistance measurement) – Insulation resistance – Testing of residual current circuit breakers (RCD/R) – Sensor testing, 6 mA RDC-DD/RCMB – Fault loop impedance (loop resistance), internal system resistance Malfunctions can be diagnosed quickly and intuitively in accordance with DIN VDE 0122-1 using the unique PROFITEST H+E EXPERT CHECK function tester for AC charging points. In addition to function tests, normative testing of the effectiveness of protective measures, i.e. electrical testing and testing of personal protection, can also be executed with an installation tester from the PROFITEST MF series or the PROFITEST MASTER IQ series. You save time and money as a result. The PROFITEST H+E EXPERT CHECK is the ideal companion for all e-mobility electricians and is used for AC charging points in charging mode 3 with a type 2 socket, or with a permanen

Test Instrument and Function Tester for AC Charging Points per IEC 61851-1, VDE 0122-1 Technical Data Mechanical Design Housing Weight Protection Display Characteristic Values Test Analysis Standard AC DIN EN IEC 61851-1 VDE 0122-1 Electric vehicle conductive charging system -Part 1: General requirements Measurement of voltage values in all three phases and N Earthing contact socket Measuring inputs CP signal output Ambient Conditions Operating tempera- -5 ... +45 °C ture Storage temperature -5 ... +60 °C Relative humidity Max. 75%, non-condensing no condensation allowed Power Supply...

Test Instrument and Function Tester for AC Charging Points per IEC 61851-1, VDE 0122-1 Product Standards The tester has been manufactured in accordance with the following safety regulations: Safety requirements for electrical equipment for measurement, control and laboratory use -General requirements Test instruments and test procedures Degrees of protection provided by enclosures (IP code) Electrical equipment for measurement, control and laboratory use -EMC requirements -Part 1: General requirements 1 PROFITEST H+E EXPERT CHECK (M525R) 1 Charging cable (micro USB plug) Description Article...