INTG7 Series A GORMAN-RUPP COMPANY Max. Fluid Temp: 203°F (95°C) Max Sys. Pressure: 75 psi Weight: 3.52 lbs (1596.645 grams) Ports: 1” MHB FLOW RATES: H2O, 12-30 VDC, 0-5v controller Max Flow: Approx. 19-20 GPM, 72-75 LPM Max Head: 66.22 Feet, 28.71 PSI Materials in contact with solution Impeller: PPS (Ryton®) Pump Shaft: Ceramic TOTAL HEAD (Feet of Water) Flow and pressure dependent on input voltage Bearing Plate: PPS (Ryton®) Housing: PPS (Ryton®) Rotor Shell: PPS (Ryton®) Static O-Ring: EPDM, FKM (Viton) Motor: Integrated, Brushless DC Supply Voltage: 12-30 VDC, 0-5v Controller It is recommended that the customer provide circuit over current protection to the pump. 300 watt pump: 10 amp fast acting fuse is recommended. Consult factory for wiring diagram and more specific instructions. Mounting Base Variable 360° rotation The above curve is an all inclusive overview of the INTG7 Series catalog models represented on this tech sheet. Gorman-Rupp Industries designs and manufactures pumps and pumping solutions for the Original Equipment Manufacturer (OEM). All models shown can be configured to meet specific OEM application requirements. Contact GRI for design points that fall outside of shown parameters. Do Not Run Pumps Dry. Pumps must be in a continuous flooded suction environment. Note: Testing performed in a controlled laboratory environment. Actual performance may vary (+) or (-) 10% from the information shown. 180 Hines Ave. • Bellville, OH 44813 • PH: 419-886-3001 • FAX: 419-886-2338 • www.GRIpumps.com GRI INTG1_INTG3_INTG7_Specifications_1016

INTG7 Series A GORMAN-RUPP COMPANY Voltage / Lead Wires Max Power Rating Watts Connections Inlet/Outlet (Inches) O-Ring Material 3-Wire: Three wires are required when the pump speed is controlled by a nominal 0-5v DC signal. This is done through a control panel such as a computer or other control devices that is connected to the pump via the third wire. The 0-5v signal controls the speed of the pump, not the voltage supplied to the pump. 2-wire: Two wires provide voltage to the pump. Speed of the pump can be changed by increasing or decreasing the voltage supplied. O-Ring Material: EPDM = Ethylene...