GlobeHeat Datasheet : Product Code GHT 8003 Product Description: Mains voltage control unit Six channel, with six P159TDA temperature programmers and 110V auxiliary outputs. Applications This versatile unit is ideal for use in supplying and controlling thermal energy in temporary and permanent furnaces, and for the internal heating of vessels for post weld heat treatments. The unit can also be used (using the correct electrical safety procedures) to power and control mains voltage, flexible ceramic pad Description When connected to a three phase 380V/415V/440V, 330A supply, this unit provides up to 240kW of heating power to up to eighteen, 4bank channel elements such as our GHT 5604, 13.3 kW channel elements. The heat treatment process is controlled by six built-in P159TDA temperature controller/programmers. Note that where three phase 380V/415V/440V, supply currents on site are limited, we can supply units where each of the six channel outputs are supplied individually from a standard 63A three phase socket. Request our product data sheet GHT 8119 ( six channel unit), or GHT 8002 (two channel unit) for further details of these units. In total, six control channels, with three elements connected in star to each output channel circuit, can be used to provide 240kW of power when the unit is connected to a 415V three phase, neutral and earth supply. Each channel output supplies three phase power to each circuit of star connected elements, via a quad cable ( see GHT6201) and a star point connection cable ( see GHT 6202-OR ) . All cables are supplied separately. The temperature of each control channel is controlled by a P159TDA temperature programmer and can be recorded via thermocouple outputs , utilizing an external temperature recorder such as our GHT 2001 or GHT 2474 ( supplied separately). Six P159TDA single channel, temperature controller/programmers Six three phase and neutral output sockets Six type K thermocouple panel mounted input sockets, and six output sockets, for connection to external temperature recorder Mains input isolator and fast acting emergency stop/power cut-off switch Multipin, Bulgin control input plug, for use with external six way programmer such as the P183: GHT 3300 supplied separately Two 110V auxiliary sockets for supplying power to temperature recorders and for recharging thermocouple attachment units (TAU) Typical set up 30m Compensating cable Star point connector Thermocouple wire GHT 9208 or stainless steel thermocouple GHT 9209 Mains voltage control unit 240V 4-Bank Channel elements heating elements GHT 5604 Globe Heat Treatment Services Ltd