10 series air operated liquid pumps
20Pages

DESIGNER AND MANUFACTURER OF HYDRAULIC AND PNEUMATIC EQUIPMENT SC HYDRAULIC ENGINEERING CORPORATION 10 SERIES AIR OPERATED LIQUID LIQUID PUMPS

A “High Pressure” History… An innovator and pioneer in the field of hydraulic engineering, SC Hydraulic has been manufacturing air-driven liquid pumps for more than a half of a century. Founded in 1953 by Bob Vedder and Willie Mohler, the company started with only a few core products. Basically air-driven liquid pumps. Today, SC Hydraulics' product line has expanded to include an extensive collection of air and gas boosters, power units, systems and selected high-pressure valves. The product line remained stable through the 1980’s seeing successful operation in an ever-increasing number of...

PRESSURE RATIO OLD & NEW PART NUMBERS In the mid 1990’s with the advent of a new inventory and computer system, SC Hydraulic Engineering was forced to change the part numbering system for better control and understanding. Prior to that time, a typical part number stated the basic series number, a ratio reference number, and a suffix if there were any modifications. Typically, a call out might be 10-500-1.5 or perhaps 10-600-20BA. The biggest change, and where some confusion may occur, is in the pressure ratio model call out for the various sizes available. The chart below can be used as an...

NO OTHER PUMPS OFFER ALL THESE ADVANTAGES Both pressure and volume of flow are easily and accurately controlled by a pressure regulator installed in the air supply line. Simple operating principle – SC air operated hydraulic pumps operate on the simple but efficient principle of pressure intensification through the use of differential areas. Fulfilling Boyle’s Law, a larger airdriven piston delivers pressure to a proportionally lesser diameter hydraulic piston, providing fluid flow at relatively higher pressures. Fluid Compatibility – Pumps can operate with almost any type fluid service...

Liquid Pump Cut-a-way SC Hydraulic Engineering – 1130 Columbia St. – Brea, CA 92821 – Tel 714-257-4800 – Fax 714-257-4810 – www.schydraulic.com Manufactured in the United States

10-4 SERIES 10-4 Series pumps have a 4” diameter air piston and a 1 ¼” stroke. Nine models are available with pressures up to 22,000 psig. When operating from 0 to rated hydraulic pressure, air consumption will be approximately 14 scfm of free air at 100 psi output. At lower air pressures and higher hydraulic pressures, air consumption will be reduced proportionately to flow rates indicated. Mounting may be in any position, vertical preferred. When mounting in an inverted position, a drain cock should be provided to drain off any liquid that may accumulate in the pilot valve air chamber....

1O1O-4 SERIES APPROXIMATE RATE OF DISCHARGE Outlet Pressure bar Outlet Pressure psig Outlet Pressure psig Liquid Flow litre/min. Liquid Flow litre/min. Outlet Pressure psig Outlet Pressure psig Liquid Flow litre/min. Liquid Flow litre/min. Outlet Pressure psig Outlet Pressure psig 7 SC Hydraulic Engineering – 1130 Columbia St. – Brea, CA 92821 – Tel 714-257-4800 – Fax 714-257-4810 – www.schydraulic.com Manufactured in the United States Liquid Flow litre/min. Liquid Flow litre/min.

APPROXIMATE RATE OF DISCHARGE Outlet Pressure psig Outlet Pressure psig Liquid Flow litre/min. Outlet Pressure psig 8 SC Hydraulic Engineering – 1130 Columbia St. – Brea, CA 92821 – Tel 714-257-4800 – Fax 714-257-4810 – www.schydraulic.com Manufactured in the United States Liquid Flow litre/min. Liquid Flow litre/min.

10-5 & D-5 SERIES 10-5 & D5 Series pumps have a 5 ½“ diameter air piston and a 1 ¼” stroke. Sixteen models are available with pressures up to 55,000 psig. When operating from 0 to rated hydraulic pressure, air consumption will be approximately 28 scfm of free air at 100 psi output. At lower air pressures and higher hydraulic pressures air consumption will be reduced proportionately to flow rates indicated. Mounting may be in any position, vertical preferred. When mounting in an inverted position, a drain cock should be provided to drain off any liquid that may accumulate in the pilot valve...

Model Code Use Top for 10-5 Use Bottom for D5 1O1O-5 & D5 SERIES APPROXIMATE RATE OF DISCHARGE Outlet Pressure bar 0 Outlet Pressure psig Outlet Pressure psig Liquid Flow litre/min. Liquid Flow litre/min. Outlet Pressure psig Outlet Pressure psig 10 SC Hydraulic Engineering – 1130 Columbia St. – Brea, CA 92821 – Tel 714-257-4800 – Fax 714-257-4810 – www.schydraulic.com Manufactured in the United States Liquid Flow litre/min. Liquid Flow litre/min. Outlet Pressure psig Outlet Pressure psig Liquid Flow litre/min. Liquid Flow litre/min.

Model Code Use Top for 10-5 Use Bottom for D5 1O1O-5 & D5 SERIES APPROXIMATE RATE OF DISCHARGE Outlet Pressure bar 0 Outlet Pressure psig Outlet Pressure psig 11 SC Hydraulic Engineering – 1130 Columbia St. – Brea, CA 92821 – Tel 714-257-4800 – Fax 714-257-4810 – www.schydraulic.com Manufactured in the United States Liquid Flow litre/min. Liquid Flow litre/min. Outlet Pressure psig Outlet Pressure psig Liquid Flow litre/min. Liquid Flow litre/min. Outlet Pressure psig Outlet Pressure psig Liquid Flow litre/min. Liquid Flow litre/min.

Model Code Use Top for 10-5 Use Bottom for D5 1O1O-5 & D5 SERIES APPROXIMATE RATE OF DISCHARGE Outlet Pressure psig Outlet Pressure psig Liquid Flow litre/min. Liquid Flow litre/min. Outlet Pressure psig Outlet Pressure psig * Recommended for continuous duty at pressure up to 30,000 psi. Intermittent duty above 30,000 psi. 12 SC Hydraulic Engineering – 1130 Columbia St. – Brea, CA 92821 – Tel 714-257-4800 – Fax 714-257-4810 – www.schydraulic.com Manufactured in the United States Liquid Flow litre/min. Liquid Flow litre/min.