1484 LINEAR POSITION SENSOR Linear or angular, configurable non-contact position sensing 25mm linear, 90° angular measurement Analogue / digital output Fully configurable range Non-contact reliability Unlimited mechanical life Submersible ANALOGUE OUTPUT Measurement range Supply voltage Over voltage protection Supply current Reverse polarity protection 10 bit over configured range Sample rate Rise time Pulse energy absorption Linear: ±12.5mm (configurable) Angular: ±45° (configurable) Voltage output range 0 - 5.6V (unless limited by V supply) Range accuracy PWM OUTPUT Measurement range Linear: ±12.5mm (configurable) Angular: ±45° (configurable) SERIAL OUTPUT Data type MECHANICAL Size Operating temperature Non-contact: no deterioration through use 2 x Ø4mm holes on a 30mm pitch 21.0 grams (0.74 ounces) excluding cable Zinc & colour passivated CR4 mild steel, EN3B painted mild steel or similar, plastic/copper foil. Contact Gill for more details Materials compatibility Water, engine oil, engine coolant, diesel fuel, gasoline, salt spray, degreaser, degreaser tsp, ammonia and dust. All common automotive liquids and materials Dither life Activator materials Sensor - activator clearance May be used as V ref or switch from V supply to ground SWITCH OUTPUT *The sensor samples the position at 1ms intervals. Each sample is processed then made available via an analogue filter with a rise time of 1.5ms. The total delay to 50% output is approximately 2ms. Wiring options: 045 = 30 AWG 6 wire (85°C) (preferred stock product) 055 = 28 AWG 6 wire (125°C) 065 = 24 AWG 5 wire (85°C) (no switch output) Zinc & colour passivated CR4 mild steel activator = 1484-30-050 More information at gillsc.com E [email protected] T +44 (0)1590 613900

1484 LINEAR POSITION SENSOR DIMENSIONS - SENSOR FIXING HOLES Ø4.0mm CABLE Ø3.4mm DIMENSIONS - ACTIVATOR The sensor requires a metallic activator to be mounted 0.5-2mm away from the sensing face. This can either be mechanically mounted to the moving object or machined into the application for minimal installation overhead. Shown right is a drawing detailing the dimensions of our recommended standard activator. Please consult Gill for more information on activator design. Sensing faces System & power ground (GND) Switch output Serial comms input (Rx), RS232 or RS485 compatible Serial comms output...