ENVIRONMENTAL SEALING SILICONE No fluorosilicone Silicone products type VMQ (ASTM D 1418) Working temperature : -70°C to +232 °C Fluorosilicone products type FVMQ ( ASTM D 1418) Working temperature : -60°C to +230°C These elastomers are used for the manufacture of molded items, extruded seals, cut flash seals and seals vulcanized in place. Thay maintain their mechanical characteristics over a broad temperature range. These products have a good resistance to solvents, fuels, organic and silicone oils. Standards Elastomer binder These elastomes are used for the manufacture of molded items, extruded seals, cut flash and seals vulcanized in place. They maintain their mechanical characteristics over a broad temperature range. Residual deformation after 22 hours at 177°C (%) Available formats : TOLERANCES OF OUR SEALING SHEET SHEET SIZE 300mm x 300mm RELATIONSHIP OF COMPRESSION FORCE TO THE CRUSHING OF MOLDED GT 37 Thickness under pressure (kg) Measurements made on molded sheet material. Measurements taken on cut out sections. The tolerances applicable for control are those shown on this page except when a FAI, a DVI, or a specific control document are requested to GETELEC. For other thickness, please contact us : up to 10 mm available All our sheets are individually checked and given certificates of conformity. Each type of sheet can be made on request in a fire-resistant version (according to UL 94). We can also provide cut sections to suit the most appropriate procedure for your requirements : Tool cut, laser cut, water jet cut and flash cut. 375 avenue Morane Saulnier 78530 - Buc, France Tel : +331 39 20 42 42 | infos@getelec