IPS
2Pages

Pressure Sensors Pressure Sensors Type IPS PPSU Inline Pressure Sensor IPS the new inline pressure sensor from AVS-Römer Inline pressure sensor for measuring pressure of liquid and gaseous media. The ceramic pressure measuring cell combined with the proven ELSA push-in connector made from PPSU is mainly used in the food industries. Push-in Fittings Other features: • minimal dead space • temperature-compensated elavation electronics • materials and constructional design especially optimised for food applications Variations / options: • other tube connections • other material for seal • other pressure range CHARACTERISTICS GENERAL Constructional design Product name Product type Nominal diameter Connection Ambient temperature Medium temperature Medium viscosity Body material Measuring cell material O-ring material Mounting method Mounting position Approval Ceramic pressure measuring cell Inline pressure sensor IPS-958P3-... DN 2.5 up to DN 6 ELSA plug fittings for pipe/tube OD 4 to OD 8 0 °C to +60 °C 0 °C to +140 °C up to approx. 35 mm2/ s PPSU (KTW approved, NSF certified) Al2O3 FKM (FDA-compliant) or EPDM (FDA compliant, KTW autorized, NSF certified) by spring clip, internal width Ø18-22 mm (not included in scope of supply) Preferably upright NSF/ANSI 169 PNEUMATIC - HYDRAULIC up to PN 16 in accordance with the specification table 0 bar up to allowable operating pressure OP in accordance with the specification table Kv-value in accordance with the specification table Gases or liquids which do not corrode the materials specified Nominal pressure Pressure range Flow rate Medium ELECTRIC Supply voltage Voltage tolerance Output voltage Electrical connection Protection class 5 V DC (24 V DC on request) ±10 % 0.5-4.5 V DC (ratiometric) (0-5 V DC, 0-10 V DC on request) 0.75 m 3-pole screened cable (LiYCY 3 x AWG 26), strand ends pre-tinned. IP65 ACCURACY Total error Temperature error zero point Temperature margin of error Response time Caution! PPSU should not be used in contact with aromatic hydrocarbons, oxidising acids, acetone, chlorinated hydrocarbons, ethers or ketones! Also, PPSU should not be placed directly in contact with anaerobic adhesives! AVS Römer . www.avs-roemer.de . info@avs-roemer.de . +49 855

Pressure Sensors Pressure Sensor - Type IPS Illustration Home Product group Max. Allow. OP at ambient temp. Tmin 0 °C, Tmax +60 °C Plastic PPSU yellow black +5 V red 0.5-4.5 V brown GND Allow. OP [bar] at medium temp. 20 °C 100 °C 140 °C Kv-value water PN [l/min] Cable screen Supply Output signal Earth Seal material Order number FKM (FDAcompliant) EPDM (FDAcompliant) FKM (FDAcompliant) EPDM (FDAcompliant) FKM (FDAcompliant) EPDM (FDAcompliant) FKM (FDAcompliant) EPDM (FDAcompliant) FKM (FDAcompliant) EPDM (FDAcompliant) FKM (FDAcompliant) EPDM (FDAcompliant) Characteristic Curve 0-4 bar or...