Mandrel-bender Mandrel-bender ... For NArrow BENDING ... In a mandrel bender, the tube is pushed over the bending mandrel into the bending machine and tensioned between the bending tool and the clamping device. The bending head turns around the bending axis and bends the tube in the bending tool. The tube is supported in the back support during the bending procedure. Using a mandrel bending procedure, it is possible to achieve the smallest possible bending radii, with the best sheet quality. Mandrel bending machines can – depending on the material used – bend tubing on a radius of 1.5 times the tube‘s outer diameter. The more thin-walled the tube and the smaller the bending radius, the more complex is the bending tool required. Different bending mandrels can be used for the bending procedure. We afford mandrel-bending machines from halfautomatic with a bending power of 28 mm up to full-automatic mandrel-bending machines with a power of up to 355 mm pipe diameter. Mandrel-bender S03-42 mm 3/4“ steel pipe as framework Control with plug Foot pedal for automatic use Castors for simple movement

Standard equipment for the S-03 mandrel bender machine series Modern electronic drive Electronic lengthening and twisting measurement Manual stop system Hydraulic tube clamping Adjustable locking pressure Four-jaw chuck Control panel Onboard Software As the first manufacturers, we offer you the following innovative solution as standard. Using the standard control console, a wide range of bending programs can be performed without using an external laptop or PC for programming. Our system determines the following parameters: • Stretched tube lengths • Feed rate • Bending angle Touchscreen onboard...