Technical Data Sheet ECOGEHR PA 6.10®
1Pages

Technical Data Sheet ECOGEHR PA 6.10® I. Physical Properties Test method Test method Test method 1. Specific gravity () 2. Water absorption 3. Humidity absorption 4a. Maximum permissible service temp 4b. Lower permissible service temp II. Mechanical Properties 1. Tensile strength at yield (S) 2. Elongation at yield. (S) 3. Tensile strength at break (R) 4. Elongation at break (R) 5. Impact strength (an) 6. Notch impact strength (ak) 7. Ball indentation (Hk)/Rockwell hardness 8. Shore-D 9. Flexural strength (B 3,5 %) 10. Modulus of elasticity (Et) III. Thermal Properties 1. Vicat-softening point. VST/B/50 VST/A/50 2. Heat deflection temperature. HDT/B HDT/A 3. Coef. of linear thermal expansion () 4. Thermal conductivity at 20 °C () 5. Glass transition temperature. (Tg) 6. Melting temperature (Tm) IV. Electrical Properties Test method Test method 1. Volume resistivity (D) 8) 2. Surface resistivity (Ro) 3. Dielectric constant at 1MHz (r) 4. Dielectric loss factor at 1 MHz (tan) 5. Dielectric strength 6. Tracking resistance V. Additional Data 1. Bondability 5) 2. Physiological.indifference according 3. Flammability 4. Limiting Oxygen Index (LOI) 6) 4. UV stabilisation 1) The physical data contained in this table are typical values and reflect the current state of our knowledge. The data are arithmetic average values which are tested by test specimens made out of rods (ø 40-60 mm). These has to be understood as guidelines, and shall not be used for specification purposes for finished parts. Missing data are completed by data of the raw materials. 2) Pretreatment necessary 3) 65 (rods 160 - 200 mm Ø) 57 (rods 220 - 300 mm Ø) 4) 59 (rods 160 - 200 mm ø), 51 (rods 220 - 300 mm Ø) 5) Physiological indifferences are valid for nature coloured materials on the raw material side. There are also approvals for our semi-finished products available or in preparation. Please check this separately with us. 6) valid for nature coloured materials. An additional UV protection can taken over by special pigments e.g. carbon black. 7) Test results without UL registration 8) Data are only valid for natural colours 9) Data taken from raw material *Self-assessment without test certificate * Own classification without official test report n.b.= no break + = yes o = limited - = no/no data available