modec actionneurs rotatifs portables www.modec.fr INTERFACES1/3 Thanks to the various interfaces, the adaptors can be used with any portable valve actuator and any head (straight, right angle or banjo). They also enable you to use the actuators for applications other than activating valves and on many types of interface other than handwheels. W INTERFACES FOR ADAPTORS SAXXX, SUAxxx AND FUAxxx WITHOUT A BANJO HEAD Using the KPA interface, you can manipulate the SAxxx, SUAxxx and FUAxxx adaptors without a banjo head. Please note, this configuration is not compatible with handwheels that have a rising stem. The KPA interface is available in 3 versions: KPA003 for the SA003 adaptor KPA004 for the SA004, SUA and FUA adaptors KPA005 for the SA005 and SA007 adaptors » HANDWHEEL PROTECTORS FOR USE WITH SAxxx ADAPTORS These protectors, integrated into the self-adjusting and self-centering fingers adaptors (SAxxx), are designed to protect the handwheel from being scratched during use. They can be built into the adaptor during assembly in the factory or added later without difficulty. They are made from high performance polyethylene, which is anti-static and resists wear and tear. Each adaptor has a corresponding interface: SA103 for the SA003 adaptor SA104 for the SA004 adaptor SA105 for the SA005 adaptor SA107 for the SA007 adaptor IMPORTANT For your comfort and safety, please carefully read the instruction manual before using the portable valve actuator.

« modec actionneurs rotatifs portables www.modec.fr We have a wide range of extension bars which enable operators to move away from the handwheel or valve, notably in the case of tapered handwheels and underground / buried valves. Light and robust, they can be used on rising stems with two maximum diameters: 30mm or 50mm. The EBX01 and EBX02 extension bars fix directly on to the CSA, CSB, FSA and FSB adaptors by one or more screw. The EBX03 and EBX04 extension bars fix on to the FUA adaptors using the TTA interface. All the extension bars can be adapted for use on the actuators using the TTA...

« modec actionneurs rotatifs portables www.modec.fr INTERFACES3/3 » INTERFACES FOR ADAPTORS FS, CS AND EXTENSION BARS The KTA and TTA interfaces enable the actuators to drive the FSA, FSB, CSA and CSB adaptors, plus the extension bars. The KTA models should be used for actuators with a straight or right angle head. The TTA models fix directly on to the banjo head. KTA (for straight or right angle heads) Maximum allowed torque: 800 Nm (590 Ib.ft) Maximum allowed torque: 800 Nm (590 Ib.ft) * SQUARE DRIVES The KTA3/4 and TTA3/4 interfaces can take a %” square drive which connects to all types...