TURNSTILES BR2-N2 PURPOSE PRINCIPLE OF OPERATION Low gate for controlling pedestrian traffic in guarded areas. The device is intended for facilities with high quality finishing. The mechanism is enabled after receiving a command signal from an external device. The internal dead bolt is electrically unlocked for the period of 10 seconds whereas the gate locked/unlocked status is displayed on the diode indicator. After enabling the mechanism (which is signalled by the green arrow), the horizontally positioned gate arm should be pushed in the signalled passage direction. After the gate arm is pushed, the power mechanism is automatically activated, facilitating the passing and disabling the revolution until it receives another command signal. In case the system operates in both directions, the gate control chip software enables memorizing the signal from external devices with alternate unlocking of the dead bolt. The system can be operated with an additional switch, installed at the job station of a receptionist, guard, cashier etc. The device uses an arm drop system in case there is no power supply. This functionality enables easy passage in emergency circumstances. The arm drop unit can also be controlled from an external relay. CASING The casing is made of 1.4301 (EN 10088) ground stainless steel. The access to the inner systems of the gate is secured with a key operated lock. Fastened to the floor with anchors, e.g. glued ones. WAY OF OPERATION The two-way system allows for controlling the pedestrian traffic in both directions or one, selected direction. Diode pictograms placed on the gate cover determine the locked/unlocked status of the gate. The red cross – gate closed, green – arrow – gate open. The electromechanical power motion of the arms makes passing (traffic) easy and supports the automatic locking of the arm system. CONTROL SYSTEM After the processor system receives a signal (free of potential) from an external device, it takes over an overall control of the system, i.e. enabling and disabling the motion of arms, and sends the feedback signal after the transfer cycle. The control system is prepared to work with access control systems systems. ______________________________________________________________________________ All rights reserved

DIMENSIONS ASSEMBLY SCHEME TECHNICAL PARAMETERS Power supply voltage Maximum power consumption Maximum current consumption Feedback signal Control signal Operation environment Environment relative humidity ELECTRICAL CONNECTIONS SCHEME STANDARD EQUIPMENT SUPPLEMENTARY EQUIPMENT PASSAGE COUNTER - a device which displays the number of passage cycles performed by the gate. PS130 TRANSFORMER - a 230/24V transformer supplied in a safe casing. Bus installation mode possible. VOLTAGE BACK-UP UNIT - The buffer power supply unit is designed for uninterrupted power supply. In case of the grid voltage shutdown,...