Gasmet Oxygen Analyzer Gasmet ZrO2 Oxygen Analyzer Gasmet 19” frame analyzer with microprocessor technology has the ZrO2 cell inside and can be used for O2 measurement in CEMS cabinets or as a portable analyzer. Together with a sampling and conditioning system Gasmet oxygen analyzer can measure the O2 content in wet flue gas or steam down to less than 1 ppm O2. Gasmet oxygen analyzer is manufactured by ENOTEC. General parameters Measuring principle: Detection limit: Response time: Sample gas temperature: Environmental temp.: Line voltage: Reference gas: Measuring gas: Calibration gas: ZrO2 measuring cell < 1 ppm O2 < 1 second 120 °C to 300 °C, non-condensing -20 °C to +40 °C 115 or 230 V / 50 -60 Hz Instrument air, dew point less than -40 °C, no oil, about 30 l/h Dry or wet, no combustibles Instrument air as above or test gas from bottles STREET ADDRESS: Pulttitie 8 A 1 00880 Helsinki, Finland

ZrO2 sensor and SME5 electronic board Sensor material: Gas connection: Gas flow: Power consumption: Heater voltage: Fuse requirement: Measurement ranges: Accuracy: Operation: Display: Spectrum: Language: Alarm display: O2 value memory: System tests: Calibration: Analogue outputs: Digital output: 316 ss (1.4571) 6 mm Swagelok Minimum 0.1 l/min 150 VA during heating 60-100 VA continuously 48 VAC for ZrO2 sensor 10 A Two (2), key selectable, each from 0-2 % O2 to 0-25 % O2 programmable, other on request ± 0.2 % of reading, maximum With softkeys, menu-controlled self-explanatory LCD display LED illuminated...