Small Immersion Heater ROTKAPPE® The Terminal Casing LC The Terminal Casing LC for small immersion heaters is made from high temperature stabilized PP (LC) or PVDF (LC/L). The protective casing is IP 65 (jet-waterproof) according to EN 60529. Access to the terminal (after fitting) when connecting the lead is also ensured by unscrewing the cap with the mounting wrench SL. The support HL offers space-saving mounting at the rim of the tank. The Immersion Heater Tube We can offer the optimum material for every application. The heated length (minimum immersion depth) is marked by a ring which is generally two-thirds of the tube length. The tube is not heated above this mark. The heated portion must always be covered with liquid even in the case of high liquid level fluctuation. The PVC connecting lead is with a standard length of 1.6 m. Other lead lengths can be provided if desired. Tube diameter Small Immersion Heater ROTKAPPE Electrical Safety The small immersion heaters are classified as “safety class 1” according to EN 60519. All metal parts that are not protected from human contact are securely connected to earth. Using non-conductive tubes made of porcelain or glass, a “protective coil“ is also fitted to the heating cartridges in order to earth these tubes. The highest possible electrical safety is therefore ensured by using an earth leakage circuit breaker (ELCB). Mounting Wrench SL Mounting Sleeve ML Support HL The ROTKAPPE small immersion heater is constructed on a modular basis and consists of a tube, a long-life heating cartridge, a terminal casing and a lead. Longlife heating cartridges are made from ceramic groove bodies with high electrical insulation values and good mechanical strength. A high temperature resistance heating wire is fitted as a coil in order to achieve the best possible heat radiation from tube to liquid. The cartridges for small immersion heaters are available in 230 volts for a single phase connection. Minimum immersion depth (heated) The small immersion heaters are used primarily in smaller plants and tanks for surface treatment and in the laboratory sector. The Long-Life Heating Cartridge Immersion tube nominal length ROTKAPPE Small Immersion Heaters are most suitable for direct heating of nearly all process liquids and corresponding applications. Excellent chemical resistance is ensured by the use of different immersion tube materials and variable fitting options help you to meet the individual requirements of heating installations. A long life span with optimum reliability is assured by using high quality materials thereby ensuring faultless operation of your system.

Safety and Quality Heating Immersion Tube Material Specifications Type Tube diameter [mm] ROTKAPPE Small Immersion Heater Tube Overview (Summary) Nominal length [mm] Minimum immersion depth [mm] Surface power density [W/cm2] 28 Special hard porcelain, glazed 28 Technical glass (hydrolytic class 1, acid class 1, alkaline class 2 according to DIN 12111, 12116 und 52322) Stainless steel (material no. 316 TI) Accessories for Small Immersion Heaters with Terminal Casing LC Enables space-saving fitting A very simple method of terminal cap LC and the lead in tank tops or tank crossscrew fixing. Material:...