In order to ensure the best possible safety, the connected temperature sensor is monitored for breakage or a short-circuit of the sensor element. In the case of a fault, the heater is switched off. Technical data Electronic Temperature Controller MTR 20 The temperature controller MTR 20 is designed specially for the rough operating conditions in surface treatment plants; their front panel is covered with a sheet which is insensitive to chemicals. The relatively small dimensions permit installation on control panels or, with the aid of a casing, close to the tank, even when space is at a premium. Easy operation and good readability thanks to the multi-colored, two-line LED display guarantee problem-free use. With the permanent display of the setpoint and the current actual value on the operating display, the status of the bath temperature can be determined at a glance. The cable connection is made by directly plugging in solid and fine-stranded conductors with wire end ferrules. The temperature controller is easily parameterized using the buttons on the front. Among other things, the following parameters can be set: Hysteresis of the switching contact, actual value correction, alarm limit value, changeover to cooling mode. Ral GALVATEK S.A.S - 9, rue de la Tour du Mesnil-Renard - 78270 Bonnieres, France www.galvatek.com - Tel. 01 30 93 07 57 - [email protected]