Angular Immersion Heaters ROTKAPPE®
2Pages

{{requestButtons}}

Catalog excerpts

Angular Immersion Heaters ROTKAPPE® - 1

Angular Immersion Heaters ROTKAPPE® ROTKAPPE angular immersion heaters are the ideal method of direct heating for all containers with a low liquid level or high level fluctuation. The heating of the liquid from the container bottom is achieved by the horizontal heated immersion tube and this ensures optimum heat radiation as well as good heat distribution. The rated power is determined by the length of the horizontal immersion tube. A relatively high heating performance is also possible because the entire tube length can be used for heating. The vertical, unheated immersion tube section can be adapted to the container depth. Nearly every desired adaptation to the container size can be realized according to specific customer requirements. The compact type of construction saves space and as a result you can plan more cost effectively. The table shows an overview of some standard types. The respective specific surface power density for the immersion tubes is stated in W / cm2 according to the heated horizontal immersion tube’s nominal length and to the rated power. An adaptation to the maximum permissible surface power density of the process liquid can be easily done by variation of the rated power and the immersion tube length. ROTKAPPE angular immersion heaters consist of the heated horizontal immersion tube, the long-life heating cartridge, the unheated vertical immersion tube, the terminal casing and the lead. Tube diameter Angular Immersion Heater with HWB Support Horizontal immersion tube nominal length (heated) ated) ROTKAPPE Angular Immersion Heater The Immersion Heater Tube The Long-life Heating Cartridge The horizontal and the vertical immersion tubes are welded together. Good chemical resistance is ensured by using the various metal immersion tube materials. A long lifespan with optimum reliability is assured by using high quality materials, thereby ensuring faultless operation of your system. Angle shaped supports are welded onto the horizontal immersion tube in order to observe the minimum distance to the container bottom or fixing. Long-life heating cartridges are made from ceramic groove bodies with high electrical insulation values and good mechanical strength. A high temperature resistance heating wire is fitted as a coil in order to achieve the best possible heat radiation from tube to liquid. The cartridges for angular immersion heaters are available in rated voltages up to a maximum of 500 volts for one, two and three phase connections. The cartridges cannot be replaced by the user. GALVATEK S.A.S - 9, rue de la Tour du Mesnil-Renard - 78270 Bonnières, France www.galvatek.com - Tél. 01 30 93 07 57 Fax. 01 30 93 25 04 -

Open the catalog to page 1
Angular Immersion Heaters ROTKAPPE® - 2

Angular Immersion Heater Materials Type Immersion tube diameter [mm] KB 45 Stainless Steel (Material No. 316TI) SB 45 Steel E 235 TI 45 Titanium (Material No. 3.7035) The Lead The PVC connecting lead is with a standard length of 1.6 m. Other lead lengths can be provided if desired. The Terminal Casing The BC terminal casing for angular immersion heaters consists of high temperature stabilized PP. Problem-free use in most process liquids is ensured by good mechanical and thermal strength as well as wide ranging chemical resistance. The PVDF terminal casing (BC/L) is recommended in cases of...

Open the catalog to page 2

All Galvatek catalogs and technical brochures

  1. Rotkappe BC

    2 Pages

  2. BC and BC/L

    2 Pages

  3. ROTKAPPE ABS

    2 Pages

  4. control box

    2 Pages

  5. Rotkappe LC

    2 Pages