MDG-118 Model 610 Automatic Applicator Controller The Model 610 Automatic Applicator is designed to dispense small deposits of paste brazing and soldering alloys or other viscous materials. Each paste deposit is precisely measured, ensuring controlled filler metal costs without waste. Features Precision digital timer and display Program dispensing times by using push buttons Unique teaching function allows fast setup of time cycles Requirements/Specifications Electrical: selectable 115 or 230 VAC, 50/60 Hz., user Air Supply: 1/4” female pipe thread inlet for clean, unlubricated shop air at 50 psi (optional filter/separator available) Operates under timed or manual mode Dimensions/Weight: 5.75”D, 5.1 lbs. High flow solenoid valve Vacuum: High efficiency, transducer design Vacuum “pullback” with fine adjustment for low viscosity materials 3.0”H x 11.75”W x Timer Range: .004 – 99.9 sec. Repeat Accuracy: ± 0.01% Footswitch and syringe stand included Cycle Rate: >600/minute Syringe stand holds both 12cc and 30cc cartridges Accessory Kit: (Sold separately) includes: (1) 3-foot plastic air line with cartridge adapter (3) 12cc or 30cc syringe cartridges (3) interchangeable needles with orifice sizes of .030”, .046” and .055” (special needle sizes available) 9-pin, D-shell connector on rear of unit permits control by an external system CE certified FUSION INCORPORATED 4658 E. 355th St., Willoughby, OH 44094 Phone 1-800-626-9501 • (440) 946-3300 Fax (440) 942-9083 • e-mail: [email protected] Web: www.fusion-inc.com