• The operator loads the assembly into a stainless steel fixture.
• Paste is applied using an automatic dispenser gun.
• Dual, zero-pressure "touch" buttons are pressed to start the automatic heating/cooling cycle.
• The joined assembly is unloaded by the operator, with a capacity of up to 60 assemblies per hour.

• Construction: The machine features a structural aluminum frame with clear acrylic guarding on three sides.
• Dimensions: The machine measures 36"W x 48"D x 34" load height, allowing the operator to be seated.
• Paste Applicator: Available in two modes: hand-held or stationary mounted.
• Heating: Includes a rigid steel gas train with air pressure switch, gas flow meter, and manifold pressure gauges. A single-axis heat slide oscillates during the timed heat cycle to prevent "hot spots." The heat manifold is quick-changeable for different parts, and Hi-Lo flame control conserves fuel when idle.
• Cooling: Features a timed air and water sequence, with water captured in a stainless steel trough. An optional water recirculating system is available.
• Fixtures: Made of stainless steel and mounted on "unistrut," with quotations based on assembly prints and parts.
• Control: Managed by a PLC with an Operator Interface Panel for adjusting timers and counters.
• Utilities: Requires 120 volts, single phase, 5 amp; natural gas or propane; 80 psi air, water, and drain.
• Oscillating burners ensure even heat distribution across the joint area.
• A hinged door provides easy access to utilities and heat controls.

Fusion Incorporated, 4658 E. 355th St., Willoughby, OH 44094
Phone: 1-800-626-9501 or (440) 946-3300
Fax: (440) 942-9083
Email: sales@fusion

Date: 3/22/2006