Website:
Furness Controls
Catalog excerpts
Pitot Static Tubes Stainless Steel Construction Sizes to suit duct diameters from 50mm to 5 metres Hand held or permanent installation Suitable for air or non-corrosive gasses High precision Pitot Tubes from stainless steel for use in ducting for the measurement of airflows. FCO65 Series Pitot Tubes have a classical design with hemispherical nose and bent shaft FCO66 Series Pitot Tubes (fore and aft static pressure) have a straight shaft with single points up and downstream. FCO68 Series Pitot Tubes (averaging Pitot tube) have a straight shaft with multiple holes upstream and single hole downstream. Pitot Tube
Open the catalog to page 1
Model Diameter Insertion length K Factor Pitot Tube FCO66 Model Diameter Insertion length K Factor FCO68 Model Diameter Insertion length K Factor General Construction Max operating temperature Stainless steel construction with silver soldered joints Standard: 250° Option: 600° All information in this document is provisional and is subject to change without notice. Furness Controls has a UKAS accredited laboratory which offers pressure calibration from 0 to 40 kPa and flow calibration from 0.1 ml/min to 2000 litres/min Beeching Road • Bexhill On Sea East Sussex • UK • TN39 3LG Tel: +44 1424...
Open the catalog to page 2All Furness Controls catalogs and technical brochures
-
FCO99 - Calibrated Leaks2 Pages
-
FCO792 - Laminar Flow Tester2 Pages
-
FCO502 - Pressure Supply2 Pages
-
FCO732 - Laminar Flowmeter2 Pages
-
FCO752 - Laminar Flowmeter2 Pages
