Vertical system coatings Fast-drying HighSolid-Systems A vertical coating system combining primer and top coat was developed for the mechanical engineering industry with the goal of offering a HighSolid-Coating System with rapid drying times and excellent corrosion protection.

Reduce throughput times with our high-solid coating system The EFDEDUR HighSolid-Primer UR1407 and EFDEDUR HighSolid coating UR1984 as a top coat were developed for the mechanical engineering industry with the goal of offering a brilliantly adhesive, resistant HighSolid coating system with excellent corrosion protection. Another main goal of the development was rapid drying. With a layer thickness of 50-70 pm (dry), the coated parts can be packed after just 60-90 minutes at room temperature. Optionally, an oven (up to 100 °C possible) can also be used to significantly shorten the drying time...

Cross-cut test: Excellent adhesion to different surfaces + = No change 1 = Very little change 2 = Little (perceivable) change 3 = Moderate change (clearly perceivable) 4 = Large change 5 = Coating layer destroyed

Suitable for use as either a single-layer or two-layer coating. Corrosion protection Thanks to its excellent resistance and general adhesion, EFDEDUR HighSolid-Coating UR1984 can also be used indoors as a single-layer coating. For higher stresses in outdoor areas, pre-priming should be performed by applying EFDEDUR HighSolidPrimer UR1407 or Epoxy-Resin FREOPOX-Primer ER1926. Structure: UR1407 with UR1984 Total layer thickness approx. 200 µm after 1,000 h SST Substrate: Smooth steel (left) Blasted steel (right) Creepage: <2 mm Subsurface corrosion: 1 mm No bubbles on surface or cut edge Also suitable...