Pneumatically Actuated Freebear Unit Square groove insertion type Instruction Manual Thank you for purchasing our product. Before use, please carefully read the following instructions to ensure proper usage. We appreciate your cooperation. 1. Summary This product is a device that assists in the transportation of items through built-in ball bearings (from now on referred to as Freebears), and its operation is controlled by air pressure. 2. Safety Precautions ・Operating air pressure：Use within the range of 0.3MPa to 0.6Mpa. ・Usage environment：For general indoor use. (0℃ to 60℃, avoid freezing and condensation) ※Heat-resistant specifications can be customized upon request. ・Ensure that water or foreign objects do not enter the compressed air system. ・When not in use, release the internal compressed air. ・Avoid severe impact to the product. ・Do not disassemble or modify the product. 3. Installation Method Add tapped holes at the installation location and secure with the provided CAP bolts. Sheet packing: Used when connecting ※Connected together with O-ring M8 CAP bolt+ SW tightening torque：12N・m

4. Piping Connection The recommended pneumatic circuit diagram for this product is as follows: Normal piping Force exhaust Air source Vacuum device ※The Freebear part of this product does not descent naturally when air is exhausted during the downward operation, due to resistance from the cylinder’s O-ring, among other factors.(Residual pressure has been released, so it will descent under the load of the transported item’s own way, etc.) If it is necessary to force the Freebear part to descend, please refer to the “Forced exhaust” circuit. 5. Connection Method This product can be connected using...

① When placing and moving transported items on this product, ensure that when Freebears rise to the highest point, the top surface remains level with the contact surface of the item. transported item When the transported item cannot be supported by all Freebears, the load capacity and the transportation ability of this product may decrease. a) lightening holes on the bottom b) protrusions on the bottom c) holes on the bottom, etc. ③ Please set up this product on a flat surface without unevenness. Do not clamp the transported item while the Freebears are in the raised position. 7. Maintenance...