ANTI-STATIC BARS NEOS 30 INTELLIGENT IONISING BARS The NEOS range of static eliminators is a major advance in industrial static control technology. NEOS intelligence monitors and reacts to the static charge by emitting the quantity and polarity of ions to neutralise it. The combination of NEOS intelligence with intense ion generation creates static eliminators for the most demanding applications. NEOS 30 is a long range static eliminator for distances between 200 mm and 1500 mm. For shorter ranges see also NEOS 20. Specification > Shockless, resistively coupled replaceable emitters made in tungsten for long life. > NEOS Intelligence has two automatic and three manual settings to give the operator complete control. See page 2. NEOS 30 Min length 600 mm then 750 mm then steps of 250 mm to 5 m. Electrical Supply: 24 V DC (21-27 V), maximum current required 2.2 A M12 5-pin connector. > Remote and local monitoring of operation and “Clean Me” function. Remote Monitor: 2 signals available: “HV OK” and “Attention” can be used to drive external loads or interface to systems (lamp, relay, PLC as required). High Voltage Supply: 30kV supply integrated into Bar. Green and Red Flash = Clean Me, attention needed. Reinforced FR-ABS Industrial grade extrusion and end cap, fully encapsulated with epoxy resin. > 100% coverage. Effective length = Overall length. No dead zone. > 24 V DC supply, M12 5-pin connector. Protection Classification: IP67. Fully sealed. Environment: Scotts Business Park, Bampton, Devon, GB, EX16 9DN T + 44 (0) 1398 331114 F + 44 (0) 1398 331411 E [email protected] W www.fraser-antistatic.com © Fraser Anti-Static Techniques Ltd 2015

NEOS Intelligence The rotary switch at the cable end of the bar gives the operator full control over the NEOS bar. The default factory setting is AUTO NORMAL for intelligent operation within the working ranges of 200 - 750 mm. AUTO LONG may be chosen if the operating distance is always toward the long end of the range. The customer may also select to turn off the intelligent modes and run the bar as a standard static eliminator. There are three manual settings for Short, Medium and Long Range Operation. AL: Auto Longer Distance AN: Auto Near Distance OVERALL LENGTH = ACTIVE LENGTH OVERALL LENGTH...