siegling blizzard * splicing equipment Siegling - total belting solutions MOVEMENT SYSTEMS

BLIZZARD SHP X00 THE NEW HEATING PRESS FOR HOMOGENEOUS BELTS The Blizzard Slim Heating Press (SHP) X00 welds homogeneous, thermoplastic conveyor belts quickly and reliably. It stands apart because it’s easy to handle and delivers excellent splicing quality in flat and patterned belts, and those that are toothed on the underside. BAND_PD BAND_CD D_FLT Can be used on all types of homogeneous belts, reinforced and unreinforced Center Drive Positive Drive

Integrated air-cooling, no cooling water required Integrated compressor for pressure generation Slim heating plates for short, homogeneous splices High productivity and short cycle times due to fully automated splicing

BLIZZARD SHP X00 COMPLETE SETS FOR ON-SITE FITTING The Blizzard Slim Heating Press (SHP) X00 is designed for the production (splicing) of homogeneous, thermoplastic belt material (Siegling Fullsan) by melt splicing. The belt ends are continuously butt spliced in the press under the application of pressure and temperature. The required impact pressure can be set as required in the press after the butt ends are fixed in place (e.g., for poorly cut edges). The Blizzard SHP X00 is a lightweight heating press for assembly and not designed for continuous operation. After several heating processes (5...

Bottom section Laminated fabric inlays top and bottom Knurled screw to adjust impact pressure Adjustment aid Inlay to fasten belt material Blizzard SHP X00, basic device without control and connection cable Delivered in sturdy transport box with rollers

The figures apply to the 230 V version. Main dimensions in mm and inches (in). All Imperial measurements have been rounded up. * If a belt is spliced and narrower than the maximum belt width specified, the area where the belt is heated must be covered all over with belt material in the same thickness. The belt holders must also be shimmed to prevent bending.

Straightforward procedure – Insert first belt edge and fasten using the adjustment aid – Insert and fasten second edge; adjust impact pressure if necessary – Close the press – Set the pressure and splicing parameters – Start splicing – Once cooling is completed, loosen the belt clamps and remove the spliced belt – Cut the sides of the spliced area Blizzard SHP X00 | The video Overview of procedure https://www.youtube.com/watch?v=48UXZNU114w Poorly cut belt ends are a significant source of errors in all splicing processes. The belt cutter BB … /X is therefore a practical accessory for the Blizzard...

Siegling – total belting solutions Committed staff, quality oriented organization and production processes ensure the constantly high standards of our products and services. Our service – anytime, anywhere Forbo Movement Systems employs around 2,500 people in its group of companies. Our products are manufactured in ten production facilities across the world. You can find companies and agencies with warehouses and workshops in over 80 countries. Service points are located in more than 300 places worldwide. Forbo Siegling GmbH Lilienthalstrasse 6/8, D-30179 Hannover Phone +49 511 6704 0 www.forbo-siegling.com,...