Ring Light VL-RGF Series
6Pages

www.fogegmbh.com info@fogegmbh.com FÖGE ELEKTRONIK GMBH Böhleswasenweg 11 72555 Metzingen +49 7123 9570508 Instruction Manual Product: VL-RGF Series Ring Light

1. Intended Use VL-RGF Series Ring Light is designed for use in industrial areas. Purpose of the product is inspection of parts, code reading, OCR and other applications need to be illuminated directly. Light is positioned between part and camera. For maximum performance use the camera as close as possible to the light. The system must be operated within the limits specified in technical data and used according to technical specifications as well as installation instructions. The system must be used in such a way that no person are in danger or machines and other material goods are damaged...

3. Dimensions / Installation System operation assumes knowledge of the assembly instructions. The symbols used for safety is shown in section 8(Safety) of manual. Camera Ordering Code Accessories Image VL-RGF-BR-01 OCR on metal moulded parts, aluminium part defect detection OCR, datamatrix code reading on metal parts marked with laser, inkjet markers Hole, defect detection on machined metal parts Metal part completeness check, positioning Picking applications, angle, position detection, part identification Concentricity measurement, part identification, part positioning ID Read on metal part...

5. Display/Controls Product does not have this specification.

6. Faults In any case do not open the product. If the leds not on check the connection and power supply. If still leds are not on contact FÖGE or distributor. 7. Warnings • Connect the power supply and the display/output device according to the safety regulations for electrical equipment. • The supply voltage must not exceed the specified limits. • Avoid shocks and impacts to the sensor. • Protect the cable against damage. Possible Results of Avoidance Risk of injury by electric shock Damage to or destruction of the sensor

8. Safety System operation assumes knowledge of the assembly instructions. The following symbols are used in these assembly instructions: Indicates a hazardous situation which, if not avoided, may result in minor or moderate injury. Indicates a situation that may result in property damage if not avoided. Indicates an electrical shock if not avoided or properly follow comments. 9.Liability for Material Defects All components of the device have been checked and tested for functionality at the production facility. However, if defects occur despite our careful quality control, FÖGE or your...