www.fogegmbh.com [email protected] FÖGE ELEKTRONIK GMBH Böhleswasenweg 11 72555 Metzingen +49 7123 9570508 Instruction Manual Product: VL-BLC Series Compact Backlight

1. Intended Use VL-BLC Series Compact Backlight is designed for use in industrial areas. Purpose of the product is inspection of inner parts, contour or part missing. Product is positioned between light and camera. For maximum performance use the part as close as possible to the light. The system must be operated within the limits specified in technical data and used according to technical specifications as well as installation instructions. The system must be used in such a way that no person are in danger or machines and other material goods are damaged in the event of malfunction or total...

3. Dimensions / Installation System operation assumes knowledge of the assembly instructions. The symbols used for safety is shown in section 8(Safety) of manual. Camera Sample Applications Ordering Code Accessories Image Part orientation, localizations, picking, classification Groove, part, dimension, completeness check Diameter, width, length measurements, part position check Diameter, angle, area, concentricity measurements, part position check Burr, completeness, quality check of the part Checking parts, holes, orientation inside transparent cover Fixing point check on plastic parts, warping,...

5. Display/Controls Product does not have this specification.

6. Faults In any case do not open the product. If the leds not on check the connection and power supply. If still leds are not on contact FÖGE or distributor. 7. Warnings • Connect the power supply and the display/output device according to the safety regulations for electrical equipment. • The supply voltage must not exceed the specified limits. • Avoid shocks and impacts to the sensor. • Protect the cable against damage. Possible Results of Avoidance Risk of injury by electric shock Damage to or destruction of the sensor

8. Safety System operation assumes knowledge of the assembly instructions. The following symbols are used in these assembly instructions: Indicates a hazardous situation which, if not avoided, may result in minor or moderate injury. Indicates a situation that may result in property damage if not avoided. Indicates an electrical shock if not avoided or properly follow comments. 9.Liability for Material Defects All components of the device have been checked and tested for functionality at the production facility. However, if defects occur despite our careful quality control, FÖGE or your dealer...