TFT | CHARACTER | UWVD | FSC | SEGMENT | CUSTOM | REPLACEMENT Graphic Display Module Part Number G12864A1-FTW-LW63 • Bottom View • FSTN Positive • Parallel & Serial Interfaces • Wide Temp • RoHS Compliant

Revision History Specification Summary First issue

Graphic LCD Features Resolution: 128x64 dots Interfaces: 8-bit parallel (8080/6800) and 4-wire Serial Built in IC Controller: (Aip31565CR) Display Mode and Backlight Variations RoHS Compliant

C1 Value 1uF~4.7uF Voltage rating 16 to 35V C2 Value 0.1uF~4.7uF Voltage rating 10 to 16V www.FocusLCDs.com

Display Type: FSTN/Positive/Transflective Backlight Type: White LED Vf=3.5V/If=60mA RoHS Compliant THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF FOCUS DISPLAY SOLUTIONS, INC. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSIONS OF FOCUS DISPLAY SOLUTIONS, INC. IS PROHIBITED <v FOCUS LCDs LCDs MADE SIMPLE® Unit: Page:

3. Input Terminal Pin Assignment NO. FSTN Type Display Module_(Ta=25°C, VDD=3.0V)

5. Electrical Characteristics5.1 Absolute Maximum Rating (Ta=25 °C, VSS=0V) Characteristics NOTE: If the absolute maximum rating of the above parameters is exceeded, even momentarily, the quality of the product may be degraded. Absolute maximum ratings specify the values which the product may be physically damaged if exceeded. Be sure to use the product within the range of the absolute maximum ratings.

6. Signal Timing Characteristics6.1 8-bit Parallel Timing Characteristics (8080-series) Parameter System Buses ReadAVrrle Characteristics (foi 30SD Series MPU} JC51

6.2 8-bit Parallel Timing Characteristics (6800-series) Parameter

FOCUS LCDs Serial Interface Parameter Serial Clock Period SCL “H” pulse width SCL “L” pulse width Address setup time Address hold time Data setup time Data hold time CS-SCL time CS-SCL time Symbol Tscyc Tshw TSLW TSAS Tsah Tsds TSDH Tcss Tcsh

6.4 Reset Timing Related Pins 1. The reset cancel includes also required time for loading ID bytes, VCOM setting and other settings from NVM (or similar device) to registers. This loading is done every time when there is HW reset cancel time (tRT) within 5ms after a rising edge of RESX. 2. Spike due to an electrostatic discharge on RESX line does not because irregular system reset according to the table below: 3. During the resetting period, the display will be blanked (the display is entering blanking sequence, which maximum time is 120ms, when reset starts in Sleep Out mode. The display remains...

FOCUSL C D s M A D E LCDsS I M P L E ® 7. Commands for Initialization of the Display

8. Cautions and Handling Precautions 8.1 Handling and Operating the Module 1. When the module is assembled, it should be attached to the system firmly. Do not warp or twist the module during assembly work. 2. Protect the module from physical shock or any force. In addition to damage, this may cause improper operation or damage to the module and back-light unit. 3. Note that polarizer is very fragile and could be easily damaged. Do not press or scratch the surface. 4. Do not allow drops of water or chemicals to remain on the display surface. If you have the droplets for a long time, staining and...