TFT | CHARACTER | UWVD | FSC | SEGMENT | CUSTOM | REPLACEMENT Graphic Display Module Part Number G12864A-FTW-LW63 • Bottom View • Transflective (positive) • FSTN Gray Positive • Parallel & Serial Interfaces • Wide Temp • RoHS Compliant

Revision History Specification Summary First issue

Interfaces: 8-bit parallel (8080/6800) and 4-wire SPI Built in IC Controller: NT7534 Built in DC to DC Circuits RoHS Compliant

Driver Method: 1/64duty, 1/9bias, VDD3.0V VLCD9.0V Display Type: FSTN/Positive/Transflective Viewing Angle: 6:00 Operating Temp: Storage Temp: Driver: NT7534 Backlight Type: RoHS Compliant THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF FOCUS DISPLAY SOLUTIONS, INC. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSIONS OF FOCUS DISPLAY SOLUTIONS, INC. IS PROHIBITED Unit: Page:

Block Diagrams NOTE: See IC controller spec NT7534 for more information on internal voltage regulating circuits. Additional information on DC-DC voltage regulating circuits for graphic LCD’s is available on our website at www.FocusLCDs.com.

3. Input Terminal Pin Assignment Recommended Connector: FH12-30S-0.5SH(55)

5. Electrical Characteristics5.1 Absolute Maximum Rating (Ta=25 °C, VSS=0V) Characteristics NOTE: If the absolute maximum rating of the above parameters is exceeded, even momentarily, the quality of the product may be degraded. Absolute maximum ratings specify the values which the product may be physically damaged if exceeded. Be sure to use the product within the range of the absolute maximum ratings.

6. Signal Timing Characteristics6.1 8-bit Parallel Timing Characteristics (8080-series) Parameter

6.2 8-bit Parallel Timing Characteristics (6800-series) Parameter

6.4 Reset Timing Related Pins 1. The reset cancel includes also required time for loading ID bytes, VCOM setting and other settings from NVM (or similar device) to registers. This loading is done every time when there is HW reset cancel time (tRT) within 5ms after a rising edge of RESX. 2. Spike due to an electrostatic discharge on RESX line does not because irregular system reset according to the table below: 3. During the resetting period, the display will be blanked (the display is entering blanking sequence, which maximum time is 120ms, when reset starts in Sleep Out mode. The display remains...

7. Commands for Initialization of the Display Command

8. Cautions and Handling Precautions 8.1 Handling and Operating the Module 1. When the module is assembled, it should be attached to the system firmly. Do not warp or twist the module during assembly work. 2. Protect the module from physical shock or any force. In addition to damage, this may cause improper operation or damage to the module and back-light unit. 3. Note that polarizer is very fragile and could be easily damaged. Do not press or scratch the surface. 4. Do not allow drops of water or chemicals to remain on the display surface. If you have the droplets for a long time, staining and...