video corpo

HOT MELT GLUE APPLICATION HEAD
2Pages

{{requestButtons}}

Catalog excerpts

HOT MELT GLUE APPLICATION HEAD - 1

adjustable coating head Flexible and accurate bandwidth control Continuous coating head with manual bandwidth control. It consists of two independent sheets, which extend from the center to the ends, and activated using levers located in the same side (operator’s side). The displacement of each sheet is measured in mm, using 4 digit meters. An independently warmed hydraulic valve is attached to the head, with pneumatic activation. GLUING SOLUTIONS As optional item, a pneumatically activated zoom in, zoom out retractable system is provided that allows the operator to remove the substrate from the coating lip when the machine stops. Due to its design characteristics, it allows operational flexibility, making it possible to work in the center of the machine or on the paper edge, laminate over horizontal or vertical substrate, independently of the direction that the substrate advances with regards to the coating lip. - Standard version: 20 to 350 mm - Configurable version: According to the attached formulas. Maximum width 630mm - Special version: Consult in case of maximum widths over 630 mm. Determining the regulation margin with the configurable version. Upon request, different margins that use the same head body may be designed for regulation widths that are other than the standard. Once the maximum width is known, the corresponding minimum width can be determined, and, vice versa, once the minimum width is known, the associated maximum width can be determined. These values are determined using the following formulas: 680 + Min. Width (mm) Max. Width (mm) = -------------------------- or Min. Width (mm) = 2 x Max. Width (mm) - 680 2 Special version In the case of regulation widths greater than the maximum limit of 630 mm, the factory should be consulted, providing information about the minimum and maximum widths, as well as the characteristics of the installation (type of machine, space available, adhesive, fusion equipment used, etc.).

Open the catalog to page 1
HOT MELT GLUE APPLICATION HEAD - 2

Adjustable coating head 20/350 (RTD-Pt100) Adjustable coating head 20/350 ND (RTD-Ni120) Adjustable head straightener rollers Power amplifier gun/head up to 3200 W (RTD-Pt100) Power amplifier gun/head up to 3200 W ND (RTD-Ni120) 968 For more information speak with your Focke Meler representative: Focke Meler Gluing Solutions, S.A. Pol. Los Agustinos, c/G, nave D-43 E-31160 Orkoien - Navarra - Spain Phone: +34 948 351 110 Fax: +34 948 351 130 info@meler.eu- www.meler.eu A Focke Group Company FT-2041/1- ENG- V0616 - FOCKE MELER reserves the right to modify the contents of this catalogue...

Open the catalog to page 2

All Focke Meler Gluing Solutions catalogs and technical brochures

  1. Arion by Meler

    33 Pages

  2. MICRONMOD

    2 Pages

  3. B4 Series

    2 Pages

  4. MACRO FOAM

    4 Pages

  5. MICRON PUR

    4 Pages

  6. MICRON MOD

    2 Pages

  7. B4 NON STOP

    2 Pages

  8. B4 VS

    2 Pages

  9. B4 VS PUR

    2 Pages

  10. MACRO SERIES

    2 Pages

  11. PS20 SERIES

    2 Pages

  12. PS200 SERIES

    2 Pages

  13. EDGING HEAD

    2 Pages