RECU-NOVO heat recovery unit

RECU-NOVO // CHARACTERISTICS RECU-NOVO heat recovery units are suitable for residential and commercial applications. Characteristics • Fully removable panels (sandwich type). • Acoustic and thermal panel insulation: thickness 10 mm for RECU-NOVO 30, 50 and 100; bigger models of RECU-NOVO, RECU-NOVO HC, RECU-NOVO F & RECU-NOVO PLUS 800 and 1000 thickness of 20 mm; thickness 25 mm for RECU-NOVO PLUS 1500 and 2000. RECU-NOVO • High efficiency aluminium plated heat recovery with airflows separated by special seals. • Stainless steel drain tray, extended to all the cooling/heating components and heat...

CHARACTERISTICS // RECU-NOVO The F versions includes: The HC versions includes: • Motor with built-in frequency converter. • Heat pump refrigeration system RC407 composed of scroll hermetic compressor, condenser and evaporator. • RECU-NOVO BF motorized integrated by pass. • High efficiency filters, class F6, F7, F8. • Air pressure switch. • Electronic built-in control for: – heating/cooling/free-cooling automatic mode (2/4 pipe plant) – antifrezee – electric heating (on/off) – winter heating speed – heat recovery defrost – manual or automatic fan speed selection – dry filter alarm – timer • Internal...

RECU-NOVO // POSSIBLE INSTALLATION RECU-NOVO / RECU-NOVO F (to consult possible configurations) Vertical unit Type A A90 Type B R90 E90 M90 fresh air return air exhaust air supply air exhaust air supply air fresh air return air E90 M90 A90 Type C M90 Type D R90 supply air E90 return air exhaust air A90 exhaust air fresh air supply air fresh air E90 R90 A90 return air M90 R90 RECU-NOVO HC A90 E90 OUTSIDE exhaust air fresh air supply air return air INSIDE R90 6 M90

RECU-NOVO // ACCESSORIES RG RQ Fan speed control Regulador integrado Suitable for wall installation, it allows to select one of the possible fan speeds. It’s composed of an electrical board, a microprocessor controller, n°03 NTC temperature sensors and a LCD remote control panel. The casing containing them is put on a side in place of the middle panel. RR Electronic control services: • Heating/cooling/free-cooling mode • Antifreeze mode • Electric heater on/off mode • BMS mediante protocolo Modbus. Unit control panel Suitable for wall installation, it allows to control the room temperature and...

ACCESSORIES // RECU-NOVO RE FX Electric heater Flexible duct join It takes place inside the unit as preheater or reheater or both in the fresh air circuit, as defrost system in the return circuit. It is complete of control relay and safety thermostat. It allows the flexible connection between the unit and the air ducts, to cut off the transmission of the mechanical vibrations due to the mobile parts of the unit. MR Way mixing box W Re-heating water coil It takes place inside the unit after the heat recovery in the supply circuit and it is useful as a hot water reheater to avoid too low supply...

SISTEMAS VENTILACIÓN Y CLIMATIZACIÓN Josep Finestres, 9 08030 BARCELONA • Spain Tel. +34 93 278 82 77 • Fax +34 93 278 82 67 www.novovent.com [email protected]