DATA SHEET FMS Tension Control / Force Sensors UMGZP-Series Force measuring block with increased stiffness as drop-in replacement for Philips series PR 9951 l Direct replacement of Philips PR 9951 No mechanical changes on machine frame corrosion resistant Overload capacity at 10-times nominal force, stainless steel construction l Highest reliability year FMS warranty 2 UMGZP-Series The force sensors of the UMGZP-Series, designed for the measurement of web tension on continuous processing lines, are used in combination with standard pillow blocks. They are designed as drop-in replacement for the discontinued Philips PR 9951 series. Block mounting is simple utilizing four fasteners into the bottom surface. The UMGZP force measuring blocks feature exceptional durability and operational reliability. Constructed of stainless steel and with their high overload protection these rugged products provide accurate web tension measurement even under the most stringent requirements. They are used in any application where an easy access to and fast change of rollers is vital. Functional description Standard pillow blocks are installed on the force measuring blocks of the UMGZP-Series. This design combines force sensor and bearing seat and allows for easy maintenance or exchange of the blocks, bearings and roll. The substantial overload protection translates to eliminated/minimized calibration issues due to machine upset conditions. The design includes dual bending beams, and this serves to eliminate the load specific influence of torque. The movement of the bending beams, which is proportional to the applied force, is detected by strain gauges arranged in a full bridge circuit and then converted into an electrical signal. This simple measurement principle delivers precise results even with low material tension and small web wrap angles. The Red Point, as located on the sensor body, should be aligned with the direction of the resultant force due to web tension.

DATA SHEET FMS Tension Control | Force Sensors | UMGZP-Series UMGZP-Series : Dimensions Orientation of the electrical connections Horizontal (resulting force) (orientation) measuring direction Setup with one force measuring block with connection S= South and one force measuring block with connection N = North. Setup with two identical force measuring blocks with connection S = South.

DATA SHEET FMS Tension Control | Force Sensors | UMGZP-Series UMGZP-Series : Scope of supply • force sensor • straight, waterproof connector (female) UMGZP-Series : Accessories • cable, 1 m (3.25 ft.) without connector • cable, 10 m (32.8 ft.) without connector • cable, 5 m (16.4 ft.) without connector • cable, 2 m (6.5 ft.) without connector • connector amphenol, 4-pole, straight • connector amphenol, 4-pole, right angle

DATA SHEET FMS Tension Control  |  Force Sensors  |  UMGZP-Series UMGZP-Series : Typical application Other products : Tension Control Tension Controllers Intrinsically Safe Barrier About us FMS Force Measuring Systems AG is the market leader in the field of web tension measurement, control and specialist for web guiding solutions. For the wire industry we are the only manufacturer offering a complete range of technologies for force measurement, data processing and radio transmission of signals. Our in house developed products are used in the manufacturing industry, converting, metals, paper,...