MELT-BLOWN POLYPROPYLENE CARTRIDGES filtration technologies Introduction Fluytec melt blown filter cartridges are made with 100% polypropylene and provide a large contact surface for minimum pressure drop, high retention capacity and high filtering efficiency. Food and drink industry. Cosmetics industry. Photographic industry. Pharmaceutical industry. Fishing industry. Process water. Reverse osmosis pre-treatment. Water-based solutions. Solar heating industry. Petrochemical industry. Detail of Fluytec melt-blown polypropylene cartridge. Depth filtration Surface filtration is achieved by a filtering medium (generally very fine) the pores of which are essentially smaller than the size of the particles to be trapped. Thus solid particles are retained by direct interception on the surface of the filtering medium. This filtration is very sensitive to preferential paths and can cause an escape of solids when the filtering medium breaks. On the other hand, in Fluytec depth filtration the filtering medium is thicker and its pores are smaller, equal to or greater than that of the particles to be retained. In this case, as well as direct interception, phenomena of initial impact and/or diffuse interception occur that allow particles smaller than the pores in the filtering medium to be retained. Depth filtration with Fluytec melt-blown polypropylene cartridges.

melt-blown polypropylene cartridges Physical properties Pressure drop Filtering medium: Polypropylene For Fluytec melt-blown polypropylene cartridges (10” long). External diameter: 60 mm Differential pressure Internal diameter: 28 mm Maximum operating temperature: 80ºC Differential pressure for replacement: 1.2 bar at 20ºC Coupling: Double Open End* Packaging: Cardboard boxes on pallets Order code *Other special couplings to order. Water flow Filtering medium: Polypropylene Fabrication method: Melt-blown Degree of micron density or nominal filtering 01 05 10 25 50 Special measurements to order....