Guidense TDR100Continuous guided level radar with point level detection Advantages □ Accurate continuous level measurement and reliable point level detection in one device. □ Best reliability in the market due to 4-wire design. □ Highly robust measurement, innovative signal analysis and disturbance signal suppression. □ Complete galvanic insulation of device electronics from its inputs/outputs and the tank potential. □ 3 Probe types: single rod probe, wire rope probe and a coaxial probe. & Fastest reaction time with 0,5 sec in the market for ^ smallest vessels / tanks. □ No influences caused by tank / vessel internals. □ Accuracy of ±3mm or 0.03% of measured distance. □ Smallest inactive areas in the market. □ The Guidense TDR100 can be used with any of the F- and D-Series level monitors and controllers. □ Active analog output according the continuous level measurement. □ Active control output for point level detection freely positionable within the measuring range. □ Suitable in almost every liquid and solids - independent of changing process conditions, such as density, conductivity, temperature, pressure, vapour and turbulence. □ All types of process and storage tank applications and has an exceptional performance in media with low dielectric constant (i.e. low reflectivity) such as oils and hydrocarbons. □ The Guidense TDR100 has almost no installation restrictions - it can be mounted in small tanks, tall and narrow nozzles and it measures precisely even with difficult tank geometries or close to interfering structures. Continuous guided level radar with point level dete

General information Probe types Introduction Guidense TDR100 The Guidense TDR100 is a guided level radar for continuous level measurement and point level detection in liquids and solids, with active analog and control output. It is very easy to install with a 4-wire system: a set of 2 wires for the power supply and separate sets of 2 wires for each output. Configuration Configuration of the Guidense TDR100 can be done directly with a set of DIP switches, a single push button and visual feedback from an LED. All settings required to get the sensor fully operational can be performed directly on...

Application specifications Mechanical specifications Materials house • Aluminium alloy EN AC-AlSi9Cu3. Cover o-ring: silicone rubber. Cover O-ring: silicone rubber. Materials probe Single rod probe: SS 1.4404 / 316L, PEEK. Single rod probe PTFE coated: PTFE, O-ring (request). Wire rope probe: SS 1.4401 / 316, PEEK. Coaxial probe: SS 1.4404 / 316L, PEEK, O-ring. Gasket at connection thread: Klingersil C-4400, 2mm Protective rating IP68 / NEMA6P. Conn. thread G 3/ A or 3/” NPT (wrench size 32mm). Max. load Single rod probe: Max. lateral load 6Nm. Wire rope probe: Max. tensile load 5kN. Coaxial...

Datasheet Guidense TDR100 Reliable Ordering information Standard configuration: Guidense TDR100-BNP-DG00-HA-RW-XX-ZX-Lxxxxx. Ordering information: Guidense TDR100 -B _ _ -D _ _ -H _ -R _ -XX Probe type BNP No probe attached. BCP Coaxial probe, max. 6.000mm. BCE Coaxial probe, with ext. application temp. max. 1.000mm (on request). BSR Single rod probe, max. 3.000mm. BSE Single rod probe, with ext. application temp. max. 1.000mm(on request) BSF Single rod probe, PTFE coated, max. 3.000mm (on request). BWR Wire rope probe with counterweight, min. 2.500mm / max. 20.000mm. Connection thread DG00 G...