1600 series
10Pages

Hydraulic gear pumps & motors 1600 1.01.01

GEAR PUMPS AND MOTORS SERIES 1600 Index: Operating parameters: Technical features and seal configuration Overall dimensions: Mounting flanges: Model coding

GEAR PUMPS AND MOTORS SERIES 1600 Operating parameters Maximum outlet pressure: Inlet pressure: Fluid temperature: Minimum at start up -40°C Maximum continuous +80°C Maximum intermittent +100°C Fluid viscosity: Minimum at start up 2000 cSt Maximum continuous 250 cSt Minimum continuous 10 cSt Optimum 15-25 cSt Contamination class: Fluid speed: Maximum (inlet) 2.5 m/sec Optimum (inlet) 1.5 m/sec Hydraulic mineral oils HL e HLP (DIN 51524) Clockwise (C), Counter-clockwise (A) and reversible (D), when available, view from shaft end For characteristic diagrams (pressure - flow - efficiency -...

GEAR PUMPS AND MOTORS SERIES 1600 Technical features Model Displacement (cc/rev) Maximum speed (RPM) Maximum torque Motor (Nm) Seal configurations Applications with radial load Applications without loads, with external drain hole to prevent the mixing of the gear box lubrication oil and the hydraulic fluid. Applications with high axial load and low radial load. High pressure seal for applications with low radial load and without check valves. High pressure seal for applications without load and without check valves. High pressure seal for applications with low radial load and with check...

GEAR PUMPS AND MOTORS SERIES 1600 Overall dimensions Single unit (side ports) Single unit (rear ports) Front unit Intermediate unit Rear unit (side ports) Rear unit (rear ports) Intermediate unit Rear unit (side ports) Rear unit (rear ports) * drain port (for motors)

GEAR PUMPS AND MOTORS SERIES 1600 Shafts * Standard mounting flange surface. DIAMETRAL PITCH EXTERNAL DIAMETER Flat root Flat root

GEAR PUMPS AND MOTORS SERIES 1600 Mounting flanges 6 HOLES ROUND ADAPTER * Standard mounting flange surface.

GEAR PUMPS AND MOTORS SERIES 1600 Ports SIDE PORTS INLET REAR PORTS INLET

GEAR PUMPS AND MOTORS SERIES 1600 Model coding P 2 C 1604 B 8 C23 C Rotation - A = Counter-clockwise - C = Clockwise - D = Bidirectional Ports (page 8): - C5 = Side ports 1” BSPP O-ring - E5 = Rear ports 1” BSPP O-ring - C9 = Side ports 1-5/16” UNF-SAE - E9 = Rear ports 1-5/16” UNF-SAE - C21 = Side ports M33x1,5 - E21 = Rear ports M33x1,5 - C23 = Side ports M33x2 O-ring - E23 = Rear ports M33x2 O-ring - L32 = Top ports 1” BSPP O-ring Mounting flanges (page 7): - 1 = “SAE A” 2 holes - 2 = “SAE B” 2 holes - 3 = “SAE B” 4 holes - 5 = “SAE C” 4 holes - 8 = 6 holes round adapter Shafts (page 6):...

Design and production of remote control components & systems The comprehensive range includes the following manufactured and marketed equipment: - Hydraulic pumps and motors - Directional control valves - Proportional pressure reducing valves - Hydraulic, pneumatic and electric joysticks - Radio controls and electronic controllers - Control pads, dashboards and armrests - Ergonomic, cylindrical and palm grips - Electro-hydraulics pilot blocks - Hydraulic filters - heat exchangers and cooling systems - Fluid monitoring and diagnostic equipment - Bell housings, driving flanges & elastic...