KREBS® mi 11 MAX™ Pumps The ORIGINAL suction side sealing pump

millMAX™ pumps technology millMAX solves this kind of problem Competitor’s suction liner and impeller - 550 hours The millMAX™ Pump has a unique patented design developed exclusively for mill discharge duties and adapted for other severe abrasive slurries. The same wet end components can be offered as a conversion kit to existing pumps, without the need to disturb the foundation or existing bearing frame assembly. The Heart of the Design The patented on-line suction side wear clearance adjustment permits the initial clearances to be maintained throughout the life of the pump. This extends the...

millMAX™ pumps In most established millMAX™ installations, wear life of parts has been even and in the majority, overall wear life has generally improved by 50% to 100%. This increase in wear life is achieved together with a reduction in power, generally in the 10% to 20% or lower range. The reduction in power can then be taken as a cost savings, or through additional pumping capacity with the same installed motor. With the millMAX™ Hybrid Suction Sealing System, the front clearance is adjusted while the pump is running, and takes only five minutes to perform. This clearance is adjusted normally...

Technical - Specifications The Krebs millMAX™ pump design includes the following: Casing - designed for minimum slurry turbulence and even wear. Includes integral wear ring, carrier, and adjustment screws for on-line adjustment and elimination of suction side recirculation. millMAX™ Power Frame • Heavy duty cast pedestal • External bearing assembly adjustment • Wide bearing centers • Heavy duty shaft and bearings. • Double clamp High Performance Centrifugal Dry Gland Seal • Large expeller diameter generates high suction level sealing capacity Zero leakage while operating Wear Ring - adjustable...

High Radial Vanes • Clears large solids • Prevents solids from being crushed • Reduces casing slurry pressure at the eye of the impeller External Wear Adjustment Screw • Four screws for on-line wear clearance adjustment • Adjusted while the pump is operating • Adjusted six to eight times during the life of the wet end of the pump Adjustable Wear Ring • Wear ring takes up clearance at the impeller • Adjusted during operation • Reduces suction side recirculation • Maintains hydraulic performance Wide Clearance • Dramatic reduction in crushing of solids • Increased wear life • Reduced power consumption...

millMAX engineering dimensions Standard millMAX discharge positions Top 45 degree Top vertical Top horizontal Bottom 45 degree Bottom horizontal Pump Model

Bare shaft pump Drive arrangements Reverse overhead Pump Model Inline with gearbox Direct drive

The FLSmidth Krebs millMAX slurry pump replaced the Warman AHF froth pump for a customer. The customer reported our millMAX centrifugal slurry pump more than tripled the life of the wet end slurry pump. We have replaced Warman pumps in many industries all over the world increasing wear life and efficiency and reducing power consumption. Our millMAX pumps are used in mining and industrial applications such as mill discharge and primary cyclone feeds, froth pumps and more. Our pumps are high quality and our field service technicians are exceptional. Our pumps are designed for pumping water, mild...