Fixturlaser PAT
2Pages

PAT The visible red laser line makes it easy to determine the position of your belt driven machines. The alignment process is as easy as the mounting. Just turn on the lasers and look at the opposite mounted unit. The laser draws a line on the target label as in the illustration below. If necessary adjust your machine position until the laser lines are aligned with the centre mark on both units. BELT ALIGNMENT Fixturlaser PAT - the final solution to all your belt alignment needs With the Fixturlaser PAT you are never in doubt on whether your belt transmissions are aligned or not. By using the groove as reference, you will achieve a precise alignment which reduces belt wear, bearing failures and vibrations. Two transmitters with visible red laser line The Fixturlaser PAT comes with two line laser transmitters, each equipped with two spring loaded guides which fit into the pulley grooves. The Fixturlaser PAT is equipped with various sized removable guides to fit standard sheave sizes A-E (6 mm - 40 mm). Additional guides for alignment of timing belts are available as accessories. The use of two laser transmitters with integrated targets makes it very easy to find out what kind of alignment that is required. Parallel offset, angular error and twist is instantly visible to the operator. Within a few minutes the operator can determine if the machine requires alignment or not.

FIXTURLASER PAT COMPLETE SYSTEM Weight (incl. all standard parts): 1,5 kg (3,3 lbs) Storage Temperature: -20 to 70°C (-4 to 158°F) CASE Material: Sealing: Drop Test: Dimensions: High Impact ABS Plastic Dust, water (5m/16 feet), and air tight with air pressure compensation valve 3 m (10 feet) on to concrete floor 250 x 180 x 80 mm (9,84 x 7,09 x 3,15 inch) MEASURING UNITS Housing Material: Extruded aluminum (molded PA cover) Operating Temp: Relative Humidity: 10 – 90% Weight: Environmental Protection: IP 65 Laser: 630 - 675 nm class II diode laser Laser Line Fan Angle: 90° Laser Power:...