
PIPE ISO-UNI PRESSURE PIPE
Open the catalog to page 1PRESSURE PIPE Pipes under pressure with cold chemical weld jointing systems (solvent welding) using suitable solvent cement WELD-ON and primer-cleaner.
Open the catalog to page 2TECHNICAL DATA REGRESSION CURVE FOR PVC-U Regression coefficients according to EN ISO 1452 and EN ISO 15493 for MRS (minimum required strength) values = 25 N/mm2 (MPa) (classification PVC-U 250). PRESSURE VARIATION ACCORDING TO TEMPERATURE For water and non-hazardous fluids for which the material is classified as CHEMICALLY RESISTANT (life expectancy 25 years). In other cases, a reduction of the nominal pressure PN is required. The information in this leaflet is provided in good faith. No liability will be accepted concerning technical data that is not directly covered by recognised international...
Open the catalog to page 3PRESSURE PIPE PVC-U pressure pipe according to standard EN ISO 1452, dark gray RAL 7011, standard length 5m
Open the catalog to page 4PRESSURE PIPE PVC-U pressure pipe according to standards EN ISO 15493 and DIN 8061/8062, dark gray RAL 7011, standard length 5m
Open the catalog to page 5PRESSURE PIPEPVC-U pressure pipe according to standards NF and CSTB NF055, dark gray RAL 7011, standard length 5m PN 16 "resale product "resale product
Open the catalog to page 6Pipe clip for ISO-DIN pipes in PP d for pipe support systems, refer to guidelines DVS 2210-1 (Planning and execution - above-ground pipe systems) Pipe clip for ASTM pipes in PP d for pipe support systems, refer to guidelines DVS 2210-1 (Planning and execution - above-ground pipe systems)
Open the catalog to page 7for pipe support systems, refer to guidelines DVS 2210-1 (Planning and execution - above-ground pipe systems)
Open the catalog to page 8The installation of thermoplastic pipe systems requires the use of support clips to prevent flexing and the resulting mechanical stresses. The distance between the clips depends on the pipe material, SDR, surface temperature and the density of the conveyed fluid. Before installing the clips, check the distances reported in the table below, as provided for by guidelines DVS 2210-01 for water pipes. Supporting PVC-U pipes conveying liquids of density 1 g/cm3 (water and other fluids of equal intensity).
Open the catalog to page 917 Pages
17 Pages
81 Pages
228 Pages
254 Pages
460 Pages
114 Pages
19 Pages
13 Pages
17 Pages
15 Pages
6 Pages
13 Pages
17 Pages
6 Pages
16 Pages
20 Pages
16 Pages
12 Pages
16 Pages
14 Pages
28 Pages
28 Pages
28 Pages
16 Pages
20 Pages
24 Pages
6 Pages
16 Pages
2 Pages
16 Pages
246 Pages
14 Pages
198 Pages
165 Pages
141 Pages
14 Pages
12 Pages
12 Pages