Ultrasonic Level Transmitter

The ultrasonic level transmitter is a non-contact, low-cost and easy-to-install measuring device. It can be applied to most industrial applications for both solids and liquids. Most important aspect of is that it is easy-to-install and low maintenance due to know moving parts. COMPACT DESIGN Compact size: equipped with 3 push buttons, 8 parameters modes and a LCD display. USER FRIENDLY OPERATION Can be configured for American or Metric system units. WORKING PRINCIPLE RAPID RESPONSE It can detect level moving up to 10m/min making it one of the industry's quickest. During operation, the device...

1. Water or waste water treatment equipment: pumps, open channels, dams and wells. 2. Edible-oils, sauces and beverages. 3. Chemicals: paints, carbons, water, crude oil, epoxy resin, lime slurry and wax. 4. Diesel, Petrochemicals, alchohols, solvents etc. panl meter Relay output Liquid measurement Silo with rotational aiming kit

2-wires (power supplied by panel meter) The ultrasonic transducer is mounted to the flange of the extension neck of the tank. Please refer to the instruction below: Length for dead band: Dead band has to be 150mm over extension neck. Dead band needs to be set as 500mm if extension neck is shorter than 500mm. Extension length: Please refer to below table and choose the suitable probe Flange Diameter of extension Diameter of extension probe L (Max) probe(f)Min size 3" 2-wires power supply (external) Keep the transducer away from sunshine

Toggle Units Default Units Level (Default) Toggle Units Echo Size Level Default Values Site Settings Display 20mA Level To save Edit Damping Display Damping Display Alarm Current Action Display Damping To save Display Action Scroll Hi/Lo/Hold Display level for 4mA To save Flash"Lrn" with Level Display "Lunx" To save Parameter Function Statement Item Set the showing value corresponds to the level or distance Set the showing value on 4~20mA (solid, distance, volume...) Set the showing value on 20mA (solid, distance, volume...) Set damping time (When the value is getting big which means that the...

CAUTION BEFORE INSTALLATION Keep the transducer perpendicular to the liquid The transducer should not be mounted too close to surface. the tank wall to avoid interference. A pipe surrounding the detection path along the Do not mount the device close to the tank wall. ultrasonic wave from emitting to receiving is Recommended. Installation can prevent false signals caused by turbulence and foam when an agitator is present. When the pipe is installed, a vent hole is required to balance the pressure difference between the inside and outside of Mount the transducer away from the inlet to avoid When...

Global Network Germany China U.S. Taiwan North America FINETEK CO., LTD. - Taipei Head Quarter No.16, Tzuchiang St., Tucheng Industrial Park New Taipei City 236, Taiwan TEL: 886-2-2269-6789 FAX: 886-2-2268-6682 EMAIL: [email protected] APLUS FINETEK SENSOR INC. - US Office 355 S. Lemon Ave, Suite D, Walnut, CA 91789 TEL: 1 909 598 2488 FAX: 1 909 598 3188 EMAIL: [email protected] FineTeK GmbH - Germany Office Frankfurter Str. 62, OG D-65428 Ruesselsheim, Germany TEL: +49-(0)6142-17608-0 FAX: +49-(0)6142-17608-20 EMAIL: [email protected] FINETEK CO., LTD. - I-Lan Factory TEL: 886-3-990-9669 FAX:...