Ultrasonic Level Transmitter FineTek

The ultrasonic level transmitter is a non-contact, low-cost and easy-to-install measuring device. It can be applied to most industrial applications for liquids. Most important aspect of is that it is easy-to-install and low maintenance due to no moving parts. The ultrasonic pulse emitted by the transducer is reflected onto the surface of the measured medium. Part of the reflected echo is received by the transducer and converter into an electrical energy signal. Ultrasonic pulses are generated at the speed of sound. The time interval from transmission to reception is proportional from the distance...

1. Water or waste water treatment equipment: pumps, open channels, dams and wells. 2. Edible-oils, sauces and beverages. 3. Chemicals: paints, carbons, water, crude oil, epoxy resin, lime slurry and wax. 4. Diesel, Petrochemicals, alchohols, solvents etc. Liquid measurement Silo with rotational aiming kit

2-wires (power supplied by panel meter) FineTek PB Meter The ultrasonic transducer is mounted to the flange of the extension nozzle of the tank. Please refer to the instruction below: Length For Dead Band Dead band has to be 300mm over extension nozzle . Dead band needs to be set as 300mm if extension nozzle is shorter than 500mm. Extension Length Please refer to below table and choose the suitable probe 20: 20mA Material level Corresponding 20mA output(M) 4: 4mA Material level Corresponding 4mA output(M)

CAUTION BEFORE INSTALLATION Keep the transducer perpendicular to the liquid surface. The transducer should not be installed too closely to the tank wall to avoid interference from the source of reflection. During installation, maintain a distance of at least 200mm from the tank wall. The recommended distance is above 500mm. Do not mount the device close to the tank wall. A pipe surrounding the detection path along the ultrasonic wave from emitting to receiving is Recommended. Installation can prevent false signals caused by turbulence and foam when an agitator is present. When the pipe is installed,...

DIMENSIONS / ORDERING INFORMATION Dimensions (Unit:mm) AC:ANS AD:DINI

Global Network Germany China Head Quarter North America Taiwan FineTek Co., Ltd. - Taipei Head Quarter No.16, Tzuchiang St., Tucheng Industrial Park New Taipei City 236, Taiwan TEL: 886-2-2269-6789 FAX: 886-2-2268-6682 EMAIL: [email protected] California, U.S. Aplus Finetek Sensor Inc. - US Office 355 S. Lemon Ave, Suite D Walnut, CA 91789 TEL: 1 909 598 2488 FAX: 1 909 598 3188 EMAIL: [email protected] Germany FineTek GmbH - Germany Office Bei den Kämpen 26 21220 Seevetal-Ramelsloh, Germany TEL: +49-(0)4185-8083-12 FAX: +49-(0)4185-8083-80 EMAIL: [email protected] Mütec Instruments GmbH - Germany...