Cerus 4 AA023 & AA024 E-Band Amplifiers
5Pages

Cerus 4 AA023 & AA024 E-Band Amplifiers Data Sheet Features 71-76GHz and 81-86Gz High Power Amplifiers Saturated powers up to >+33dBm High linearity supports 256QAM modulation Wide 5GHz bandwidth >20dB gain Suitable for military or commercial applications Low SWAP for airborne & HAPS applications Cerus 4 Amplifier Block Diagram Interface Connector Filtronic’s range of Cerus amplifiers provide market leading linear mmW power. Available in single to N-way configurations, the Cerus power amplifiers deliver unparalleled performance for long range E-Band communications. The Cerus 4 E-Band amplifier modules each contain 4x Filtronic GaAs HEMT PA MMICs performance matched and power combined in waveguide to deliver maximum power. An integrated temperature sensor provides users with accurate amplifier temperature data, and optional control circuitry facilitates functions including gain control, mute control and alarms. Proven system performance – Demonstrated in systems supporting 256QAM Field proven technology – >50,000 Filtronic millimetre wave transceivers deployed worldwide.

Cerus 4 AA023 & AA024 E-Band Amplifiers Data Sheet AA023 Outline Specification Parameter Over baseplate operating temperature -40 to to +70C All RF parameters referenced to waveguide output port. Typ. Small Signal Gain Tx Power control range Absolute maximum RF input power Supply voltage 1 Supply current 1 Supply voltage 2 Waveguide input & output: WR12 Interface DC connector: IPL1-112-02-L-D-K (without CTRL board) DC connector: IPL1-110-02-L-D-K (with CTRL board) AA024 Outline Specification Parameter Over baseplate operating temperature -40 to to +70C All RF parameters referenced to...

Cerus 4 AA023 & AA024 E-Band Amplifiers Data Sheet AA023/AA024 Control Board pinout Connector CON1 IPL1-112-02-L-D-K Connector CON1 Connector CON1 controls the drain currents of the HPA assembly. The length of the wire harness must be as short as possible. Negative power supply. Power supply Ground. All four pins are connected together and to the metalwork. Positive power supply. All four pins are connected together. Fast transient response power supply with current limit at least 7A is highly recommended. CMOS input with 3.3V logic level (5V tolerant). When ENABLE < 0.6V DC or left...

Cerus 4 AA023 & AA024 E-Band Amplifiers Data Sheet AA023/AA024 Temperature sensor The HPA assembly contains a temperature sensor with analogue output. There is a low pass filter at the output. When measuring the output voltage make sure that the input impedance of the meter is high enough to avoid measurement errors. Temperature sensor transfer function The transfer function of the temperature sensor can be approximated with the following polynomial, where x is the measured voltage in mV and T is the temperature in °C. T=a0+a1*x+a2*x^2 a0 = 181.765094640206 a1 = 0.10716443871271 a2...

Cerus 4 AA023 & AA024 E-Band Amplifiers Data Sheet Temperature sensor transfer table Temp Contact Us Filtronic. NETPark Plexus 1, Thomas Wright Way, Sedgefield, County Durham. TS21 3FD. UK Tel: +44 1740 618 800 Email: sales@filtronic.com All specifications are subject to change without notice. Visit www.filtronic.com for the most current datasheets. © 2022 Filtronic plc. All rights reserved.