MCT information
5Pages

PARTS N.R.W.X,Y&Z ARE AVAILABLE AS A SEAL KIT PARTS BB.CC.DD.FF.GG.IIJJ.U MM NN ARE AVAILABLE AS A CENTRE TUBE SEAL KIT

«CHKING CONDITIONS Fluids:- Mineral Oil, machine tool coolants and compressed air (lubricated} • All fluids should be clean and free from abrasive particles. Special tungsten carbide seals are available for abrasive conditions. Speed - 1,500 rpm maximum without a locating spigot 3,000 rpm maximum with a locating spigot. IT IS NOT ADVISABLE TO COMBINE MAXIMUMS. If the Rotary (MCT) Union to be fitted has been in stock for more then 3 months, it should be rotated without pressure for The end of the machine shaft should be prepared with a concentric female B.5.P. parallel thread, handed right...

Stationary connection for the service fluids should be made with flexible hose as shown in the diagram below. DO NOT RIGIDLY PIPE. DO NOT FIT THE FLEXIBLE HOSE IN TENSION, COMPRESSION OR TWISTED. DO NOT FIT VALVES, ETC. TO THE RLTARY (MCT) UNION. The fitting* shown in the tables can be provided to connect the services to the Rotary (MCT) Union. Flexible Hostl mild steel ends for Rotary (MCT)Union Nominal Size Type braid reinforced ynthetic rubber with fixed male plastic with fixed male mild INSTALLATION AND MAINTENANCE DETAILS FOR ROTARY (MCT) UNIONS FILTON LIMITED

The 1fILTGN MECHANICAL SEAL• fitted to the Rotary (MCT) Union is self adjusting within it's working life. The pre-loaded angular contact ball bearings fitted are prepacked with a special grease which has long life and low internal friction, keeping the temperature lower than conventional bearing greases at high speeds. Re-lubrication need only be carried out at overhaul petiods. Bearings and seals should be changed when leakage occurs. The Rotary (MCT) Union is easily dismantled for overhaul the following method with reference to the exploded drawing IMPORTANT - FOR ROTARY UNll.NS TYPE RS...