Maxipulse Gear - Large Capacity Positive Displacement Flowmeters The Maxipulse range of positive displacement flowmeters offer a high level of accuracy and repeatability. These precision meters are used for flowrate measurement in flow monitoring and control applications and for totalising in dispensing and batching. Maxipulse meters are suitable for use with a wide range of clean liquids including viscous lubricants, fuel oils and fuels or non-conductive low viscosity solvents either pumped or gravity fed. F E ATU R E S / B E N E F I TS • • • • • • • Flows: 50~1500 litres/min ( 13 ~400 US gal/min ) Size: 80mm and 100mm (3” & 4” process connections)* High accuracy & repeatability No requirement for flow conditioning ( straight pipe runs etc ) Simple to install, easy to service ( low number of parts ) Intrinsically safe & explosionproof models available Quadrature pulse output option & bi-directional flow * see also Micropulse & Multipulse data sheets for other size meters & flow ranges M E T E R S E L E C TI O N Meters are selected based on flow range, pressure, temperature, material compatibility and functionality. • Maxipulse Gear meters meters are ideal for bio-diesels and petroleum derivatives such as oils, grease, fuels and fuel oils. Maxipulse are available as blind meters with pulse output or with integral or remote totalisers, flow rate displays or preset batch controllers. Pulse meter outputs can be interfaced to most electronic displays or instrumentation. The reed switch is used when external power is not available and can be used in intrinsically safe loops. The output from the hall sensor is an NPN open collector providing high speed solid state pulses ideal for precise dispensing and batch control. A P P L I C ATI O N S I N C LU D E Fuels, oils, grease, lubricants, additives, alcohols, insecticide, solvents, inhibitors and some emulsions & oil based paints. TRIMEC INDUSTRIES 1/19 Northumberland Road, Caringbah NSW 2229 PO Box 2444 Taren Point NSW 2229 Sydney Australia Ph: +61 2 9540 4433 Fax: +61 2 9525 9411 email: [email protected].

Model coding Model prefix: * Maximum flow is to be reduced as viscosity increases, max. pressure loss 100Kpa. (15psig) Body material A Aluminum Rotor material 4 Aluminum Bearing type 4 Hardened steel needle roller bearings O-ring material (1) 120°C (250°F) rating of the pulse meter, 80°C (180oF) rating with BT, RT & EB options. See temperature code 5 for higher temperature with BT, RT, & EB (2) Cooling fin is fitted with integral instruments for operation from 80~120°C ( 180~250°F ) INTEGRAL AND REMOTE INSTRUMENTS Integral Instruments Panel Instruments Dual Totaliser Preset RateBatcher Totaliser...