
Group: Fiamgroup
Catalog excerpts

Cordless Freedom. Working everywhere with maximum productivity. Cordless screwdrivers • Torque range: 0,8 12 Nm • Speed: 200 * 1550 rpm • Automatic electric shut-off • Low-speed models
Open the catalog to page 1
BRUSHLESS MOTOR • Without brushes • Low maintenance • Longer tool lifetime • Reduced pollution • Quite operation ERGONOMICS • Ergonomic grip with soft grip • Reversing can be operated with buttons located near the thumb on both the right and left of the tool. Very comfortable for left-handed operators • LEDS to light up the working area • Audible and visual signal to aid the operator LITHIUM-ION BATTERY • Great working uptime • Fast recharge (60 minutes) • Easy attached sliding battery system
Open the catalog to page 2
PROCESS UNDER CONTROL • The automatic shut-off torque control system stops power supply when preset torque is achieved • imed start trigger to avoid repeated start on T already fastened screws • utomatic return in tightening mode after A untightening (function to be programmed) • tart-up delay between two tightening S operations: the time between two tightening operations can be set to prevent double attempts on screws already tightened. PROGRAMMABLE START-UP Settable modes: • tart at maximum set speed S • Adjustable slow start • Slow start + maximum speed. PROGRAMMABLE UNTIGHTENING • he FR...
Open the catalog to page 3
Type Type Tightening torque Legend Reversibility: all models are suitable for tightening and untightening operations The tool supplied turns at the max speed as specified in the catalog, however speed can be adjusted according to the type of application using an accessory called Speed programmer (available upon request) • The tightening torque values has been measured in accordance with ISO 5393 standard. • Noise level has been measured in accordance with ISO 3744 and ISO 15744 standards. • Vibrations level has been measured in accordance with ISO 28927-2 standard. • Accessory drive: female...
Open the catalog to page 4All FIAM catalogs and technical brochures
-
eTensil for manual use
42 Pages
-
Torque readers
8 Pages
-
Auto feed tightening module MCA
40 Pages
-
Air motors
50 Pages
-
Tightening automation
16 Pages
-
Air angle nutrunners
22 Pages
-
Aerospace Solutions
42 Pages
-
Drills-30F
10 Pages
-
Air grinders and sanders
16 Pages
-
26C Air screwdrivers
20 Pages
-
15C Air screwdrivers
20 Pages
-
AM-Automatic nut presenter
4 Pages
-
Air screwdrivers CDE
4 Pages
-
Air nutrunner motors 40 Nm
24 Pages
-
Air drills
24 Pages
-
Air tappers
16 Pages
-
Air screwdrivers 15C
16 Pages
-
Oil pulse wrenches IHE
4 Pages
-
Air marking pen
2 Pages
-
Air inserting tool IP900
4 Pages