Product Range
8Pages

mass flow controller flox[on] B S J P r e s s u r e Controller Flox[on] P

PRODUCT FEATURES GASES Calibration media (see also chapter calibration) Process media (gas) EQUiPMENT Connection M8 power supply Connection M12 analog LED display operating mode Micro USB Port Software "Regulation Tuning" MATERiALS Housing Valveparts Inlet / Outlet Port Sealing Protection FC Techmk I Product Range I Mass Flow & Pressure Controller I Release 6.0, May 2020

PRODUCT FEATURES Calibration media (see also chapter calibration) Process media (gas) Housing Valveparts Inlet / Outlet Port Sealing Protection Release 6.0, May 2020 I Mass Flow & Pressure Controller I Product Range I FC Technik I 3

PRODUCT FEATURES 24 ± 15 % set and real value 1, two colours Connection M8 power supply Connection M12 analog LED display operating mode Micro USB Port Software "Regulation Tuning" GAS CORRECTiON FACTOR Hydrogen1 Argon Nitrogen Oxygen Methane Carbon dioxide Before delivery, the measuring cell in every flox[on] is calibrated with atmospheric air. There are correction factors for applications using other gases. In individual cases, if desired by the client, the calibration can be made directly with the specific gas intended for use. For all other questions about calibration, please contact...

PRODUCT FEATUERES FLOX[ON] PRESSURE CONTROLLER Connection M8 power snpply Nlmm-1 LED display operating mode Micro USB Port Software "Regulation Tuning" EQIPMENT MATERIALS Housing Valveparts Inlet / Outlet Port Sealing Protection * In individual cases, if desired by the ** In other cases a compatibility check is customer, the calibration can be made required. directly with the specific gas intended for use. The flox[on] pressure controller controls the outlet pressure and compensates fluctuations of the inlet pressure. The set value is the target pressure and the real value the actual...

flox[ o n] P re ssure c o ntro l gas flow of the flox[on] series

The software for flox[on] B can be downloaded. It requires Windows. The software enables to operate the flox[on] B without any other process control. The software allows to: • to get all information about the device, • to see and to manipulate the calibration data, • to have a look at the actual operation and to overwrite the set point. Though the measuring cell does not require a recalibration for the rest of its lifetime it might be possible in very special processes to manipulate the calibration (here done in changing three calibration points, that are green marked). Before using this...

FC Technik AG St. Gallerstrasse 340 CH-8409 Winterthur www.fc-technik.com info@fc-technik.ch