Catalogs >
FCTechnik - Gas Control Systems - flox[on] MFC >
data sheet flox[on] B new

data sheet flox[on] B new
3Pages

Catalog excerpts

FCTechnik M ass f low contr o ller Data sheet flox[on] B | October 2016 | Page 1 7 1 Proportional valve 2 Outlet flange with thread connection 3 Inlet flange with thread connection 4 M8 Power supply 5 M12 Connector signal interface 6 Micro USB port 7 3 LEDs operating mode backsight of flox[on] B economy and extended frontsight of flox[on] B stainless steel connection assignment The USB Port connects the flox]on] B with a PC. LED and operating modus Real value 4-20 mA > AIP Real value All information is provided in best conscience. Some clients may desire certain modifications which lead to results other than those found in this manual.

Open the catalog to page 1

FCTechnik M ass f low contro ller Data sheet flox[on] B | October 2016 | Page 2 Data sh eet flox[on] B | October 2016 | Page 3 ava i la ble m o d ificatio ns o f flox[ o n] B The measurement of all flox[on] B mass flow controller is based on the principle of thermal anemometry. The measuring cell is located in a bypass. The measurement of the gas flow is temperature and pressure compensated. The regulation of the flow will be made by a pressure compensated proportional valve which is insensitive to incoming pressure (0-16 bar) as well as outflow pressure. The valve is controlled by a...

Open the catalog to page 2

Data sheet flox[on] B | October 2016 | Page 4 T o ensure trouble-free operation, the flox[on] B should be installed in a horizontal position. If installed vertically, the device could produce faulty measurements under certain conditions. Before delivery, the measuring cell in every flox[on] B is calibrated with atmospheric air. There are correction factors for applications using other gases. In individual cases, if desired by the client, the calibration can be made directly with the specific gas intended for use. The flox[on] B is maintenance-free even under harsh conditions. In case of a...

Open the catalog to page 3