Precious Metal Commutation Series 1218 ... SXR Values at 22°C and nominal voltage Nominal voltage Terminal resistance Rotor inductance Efficiency, max. No-load current, typ. No-load speed Stall torque Rotor inertia Friction torque Torque constant Speed constant Slope of n-M curve Thermal resistance: – winding to housing – housing to ambient (external plastic flange) – housing to ambient (external metal flange) Thermal time constant: – winding – housing (external plastic flange) – housing (external metal flange) Operating temperature range: – motor – winding, max. permissible Shaft bearings Shaft diameter Radial shaft load max.: – dynamic at 3 000 min-1 (3 mm from bearing) Axial shaft load max.: – dynamic at 3 000 min-1 – static (shaft unsupported) – static (shaft supported) Shaft play, max.: – radial – axial Speed up to Number of pole pairs Mass Housing material Magnet material Rated values for continuous operation Rated torque Rated current (thermal limit) Rated speed Note: ball bearings, preloaded 1,5 Rated values are calculated with nominal voltage and at a 22°C ambient temperature. The Rth2 p value has been reduced by 0%. Note: The diagram indicates the recommended speed in relation to the available torque at the output shaft for a given ambient temperature of 22°C. The diagram shows the motor in different conditions of thermal coupling, i.e. mounted respectively on a plastic flange and a metal flange. The nominal voltage (UN) curve shows, up to the thermal limit, the operating point at nominal voltage for the motor mounted on a plastic flange. Higher torque can be achieved by further reducing the thermal resistance. Any points of operation above the curve at nominal voltage will require a higher operating voltage. Any points below the nominal voltage curve will require less voltage. Plastic flange Metal flange Intermittent operation Operating point at nominal value Recommended operation areas (example: nominal voltage 18V) For notes on technical data and lifetime performance refer to “Technical Information”. Edition 2024 Dec. 18 © DR. FRITZ FAULHABER GMBH & CO. KG Specifications subject t

Dimensional drawing Bearings Encoder combination Temperature range Temperature range Temperature range Bearings Bearings Leads Leads Leads Leads Shaft end Motor with 2 preloaded ball bearings Motor with rear end shaft for combination with Encoder IEP3 Extended temperature range (-30°C…+125°C) Motor with 2 preloaded ball bearings, extended temperature range (-30°C…+125°C) Motor for combination with Encoder IEP3, extended temperature range (-30°C…+125°C) Special sintered bearings for vacuum of 10-5 Pa @ 22°C Special ball bearings for vacuum of 10-5 Pa @ 22°C Motor with twin leads (PVC), length...