
This document is a Certificate of Compliance issued by ISET S.r.l. for Fatech Electronic (Foshan) Co., Ltd., certifying conformity with the Low Voltage Directive 2014/35/EU.
The certificate covers Surge Protective Devices with the following models:
The verification was conducted voluntarily based on documentation provided by the manufacturer. The product meets the requirements for the ISET Certification Mark according to ISET regulations.
The manufacturer is responsible for maintaining internal production controls to ensure ongoing compliance. ISET disclaims liability for any noncompliance related to documents, products, or test reports submitted for evaluation.
Marking and EC declaration are the manufacturer's responsibility before market placement. The verification does not imply assessment of production processes. The manufacturer must comply with all applicable directives and procedures before applying the CE mark.
Improper use of this verification is the manufacturer's responsibility.
Certification Manager: Not specified in the document.
ISET S.r.l. Sede Legale e Uffici Via Donatori di sangue, 9 - 46024 Moglia (MN) Tel. e fax +39 (0)376 598963 [email protected] www.iset-italia.eu Cap. soc. i.v. Cod. Fisc. e P.IVA Reg. Imprese REA CERTIFICATE OF COMPLIANCE Certificado de Conformidade - Сертификат соответствия - Konformitä tserklä rung 1) APPLICANT: 2) CERTIFICATE NO.: Fatech Electronic (Foshan) Co., Ltd. IT061448FT170518 2nd floor,Bldg D7,Guangdong New Light Production Base, Luocun,Shishan Town,Nanhai District,Foshan City, TCF(S) NO.: Guangdong Province,China. QT-1702007-LVD 3) WITH REFERENCE TO EC DIRECTIVE APPLIED: Low Voltage Directive 2014/35/EU 4) CERTIFICATION ISET MARK: HARMONIZED STANDARDS APPLIED: EN 61643-21:2001+A2:2013 5) PRODUCT CHARACTERISTICS: Surge Protective Device MODEL(S):FS-RJ45-6/100, FS-RJ45-6/1000, FS-RJ45D/POE-100, FS-RJ45D/POE-1000, FS-RJ45W/POE-1000, FS-RJ11, FS-BNC, FS-DR, FS-CCTV/2, FS-CCTV/3 REMARK: The verification has been carried out on voluntary application of the manufacturer based only on the documents prepared and provided by the manufacturer itself. The product(s) satisfies the requirements of the Certification Mark of ISET according to the ISET regulations. The manufacturer is responsible to maintain the internal production control to ensure the compliance of the product. ISET declines any liability with reference to any other noncompliance of documents, product or test report that have been submitted to evaluation. However marking and EC declaration are duties of the manufacturer before putting into service of its product(s) on market as well as the verification doesn’t imply assessment of the production of the product(s).The manufacturer is liable to take all the necessary actions required by the applicable directives&procedures before putting CE mark on the product(s).The manufacturer should be responsible for the results caused by improperly use this verification. CERTIFICATION MANAGER:
Open the catalog to page 13 Pages
3 Pages
3 Pages
2 Pages
3 Pages
2 Pages
4 Pages
4 Pages
3 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
2 Pages
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page