Fatech portable surge generator FPT15-I surge arrester testing

1 / 1 PageView full catalog

Fatech portable surge generator FPT15-I surge arrester testing

Product catalog summary

Characteristics:

Portable type, small size.
On-site testing of lightning counter.
Demonstration of SPD (Surge Protective Device) working.
One-key operation for charging and discharging.
Maximum discharge current of 2.5kA.

Introduction:

The FPT15-I Portable Surge Generator is designed for on-site testing of surge protective devices and lightning strike counters. It can release a maximum discharge current of 2.5kA and features a one-key operation for charging and discharging. The process is initiated by pressing the green "Start" button, which begins charging and timing until the device stops charging and discharges. The test concludes when the time relay's indication light turns off. Note: The green "Start" button should not be pressed repeatedly during testing.

General Specifications:

Dimensions: 360 x 345 x 160 mm
Weight: 11 kg
Case Material: Steel
Operating Temperature: 0℃ to 40℃
Operating Humidity: ≤75%
Storage Temperature: -10℃ to 50℃
Power Supply: AC-220V

Panel Introduction:

The control panel manages the surge generator's charging time, initially set to 3 seconds with an output voltage of 1100V and a surge current of 2.5kA. To reduce the output surge current, the charge time can be adjusted accurately to 0.1 seconds using the time relay.

Technical Data:

Allowable Tolerance of Impulse Current: Front time 8μs ±10%, Time to half value 20μs ±10%
Surge Current: 2500A
Over-impulse Range: <20%
Max Charging Voltage: 1100V
Power Consumption: 50W
Charging Voltage Display: 4 Digital LED display

Catalog excerpts

Fatech portable surge generator FPT15-I surge arrester testing-1

Test Device FPT15-I ♦Introduction FPT15-I Portable surge generator is designed for on-site testing of surge protective device and lightning strike counter.The surge generator is able to release max. discharge current 2.5kA, realized one-key operation of charging and discharging. Press the green “Start” button, the surge generator starts charging, the relay starts counting time until the device stop charging, while discharging. When time relay’s indication light off, the test end. Note: Green “Start” button cannot be repeated click during testing. ♦ Characteristics: -Portable type, small size. -On site testing of lightning counter. -Demonstration of SPD working. -Realized one-key operation of charging and discharging -Max. discharge current 2.5kA ♦ Panel Introduction Control surge generator charging time. The original setting display as 3S, output voltage is 1100V, output surge current is 2.5kA. If need to reduce output surge current, you can reduce the charge time, that is to adjust the time of time relay, it can accurate to 0.1S. Real-time voltage,, Charging Time Charging Voltage Control charging and discharging procedure. Check the lamp ON or OFF before and after the test. Output current waveform, testing surge protective device or other products.

Open the catalog to page 1