FGA 342 SAFETY MANUAL AND INSTRUCTION MANUAL SPOT REPAIR SANDER The reproduction of this document (even in partial form) is prohibited without the Fasangas S.r.l. authorization

GENERAL WARNINGS TECHNICAL FEATURES OF THE TOOL IMPORTANT SAFETY INSTRUCTION FUNCTIONAL INSTRUCTIONS DISPOSAL INFORMATIONS

1. GENERAL WARNINGS Before to use the tool, please read carefully the instruction contained in this manual. Improper or unsafe use of this tool can result in death or serious bodily injury. This manual of instructions constitutes an integral part of product and it has to be edited by the end user for every possible future consultation. It contains important informations about the safety use of the product. USE DESTINATION. This tool and its accessories, must only be used for the purpose for which they have been conceived. A considered improper and unreasonable act possible damages caused by improper,...

3. IMPORTANT SAFETY INSTRUCTIONS When using this air tool, the following basic safety precautions should always be followed to reduce the risk of personal injury: Always wear safety glasses with side shields (DP I- Dir .89/686/EEC) Air powered equipment are capable of propelling materials such as metal chips, saw dust and other debris at high speed, which could result in serious eye injury. Tool attachments can become loose or break and fly apart propelling particles at the operator.Compressed air can be hazardous. propelled by the stream can cause injury. Always wear hearing protection (DPI...

ATTENTION: - Never carry the tool by the hose. Always hold the tool only from the the ergonomic handle it is endowed. - Never wear loose fitting clothes, or apparel, which contains loose straps or ties, etc. which could become entangled in moving parts of the tool. Remove any jewelry, watches, identifications, bracelets, necklaces, etc. which might become caught by the tool. - Remove air hose when tool is not in use and store tool in secure location away in particular from reach of children. - Before removing the compressed air supply hose from the tool, make sure to have previously closed the...

d) Place the Sandpaper on the sandpad. The specification of sandpaper ranges from #120 to #1500. Also note that, the maximum operating speed which the sandpaper can afford shall be higher than the rotation speed of this tool. ATTENTION - With this tool, use only accessories (sandpads) reccomanded from the producer. - Do not use hand accessories because they are not endowed of appropriate locking systems. - Before assembly the accessories on the tool, always check the integrity of their locking systems. e) Connect tool to air hose of recommended size (see the Technical specifications paragraph...

To lubricate the air motor manually: Disconnect the tool from the air supply holding it so the air inlet faces up. Depress the trigger and place 4 or 5 drops of #60 spindle oil at the air inlet. NOTE: use of a thicker oil can lead to reduced performance or malfunction of the tool. If a thicker oil is used by accident, put out it immediately. Connect the tool to an air source, cover the exhaust end with a towel and run for a few seconds. Every 3 or 4 hours of operation, oiling is necessary. Do not lubricate tools with flammable or volatile liquids such as kerosene, diesel or jet fuel. ATTENTION...

9. WARRANTY This instrument is warranted to be free from defects in materials and workmanship (for a normal use of service) for a period of one year. Any instrument found detective within one year from the delivery date and returned to the factory with transportation charges prepaid, will be repaired, adjusted, or replaced at no the defect has been caused by a misuse or abnormal operating.